Diablo PergoBlade Saw Blade for Laminate and Wood Flooring - 10" Diameter, 12-Teeth, 5/8" Arbor, .087" Kerf, 10° Hook Angle, .063" Plate, 6000 Max RPM - D1012LF

I did a previous Pergo installation using a regular table saw blade for ripping the pieces and I had assumed that the blade was already dull and that is why my saw struggled. This time I used a blade I knew was sharp and made for making fine cuts. Within a few boards, I could hear a change in my saw. The blade was being eaten up. This was a nice Dewalt blade too. So I purchased this blade to spare what was left of my existing one and WOW. This thing just glides through Pergo. I have ripped several more boards and there has been no change in my saw's performance. So far it has been well worth the cost. At this rate, it seems like it is going to make it through the rest of this 1100 sq ft project and probably the next 1100 when I do the downstairs.

I bought this blade to cut 12mm laminate flooring. I have installed 600 sq ft and stairs with 15 steps and it still cuts as good as the first board. I bought a 12" for my miter saw and a 10" for my table saw.

If you are cutting LVP you need this blade. Other blades will dull with 2-3 cuts. This did the whole job (Whole house).

This is the best laminate blade I have ever used by far! I tend to install AC5 rated laminate, and the aluminum oxide wear layer is really hard on blades. The previous brand of laminate blades I tried were worn out after cutting 6 planks! This blade I have used for six large rooms so far, and it still goes through the laminate like a hot knife through butter. Well worth the investment.

I bought this blade for a laminate flooring project. I heard that this kind of flooring just ate up regular saw blades so I looked into this blade as replacement. At first I was a little skeptical because of the price. I looked for other alternatives, and to my surprise nearly all were more expensive and reviews didn’t seem to suggest that they were as good as the experience with this bad. After three days of hard use, the blade hasn’t even lost the paint coating on it and it is cutting like the first cut. It’s a devilishly good saw blade.

Gets the job done - lasted for the entire job.

Great blade and made very clean cuts in the Home Depot Life Proof LVP flooring I put in… That being said, It makes a F’n mess, luckily I was making my cuts outside. Looking back I should have purchased the vinyl floor cutting tool.

Great blade. I thought for sure just any old blade would work for laminate flooring, but I was wrong. After switching to this blade the cuts were prefect (rip and chop) and the blade didn't overheat at all. If I had to do this for a large project, I'd get one for my chop saw and one for the table saw so that I didn't have to switch back and forth. Even after two rooms it has tons of life left in it... not dulled at all.