🔥 Elevate Your 3D Printing Game!
The Gikfun 100K Ohm NTC 3950 Thermistor Temperature Sensor is a high-precision component designed for 3D printers, featuring a resistance of 100KΩ with a ±1% tolerance and a B value of 3950. This pack of 10 ensures you have reliable sensors ready for any project, delivering consistent and accurate temperature readings.
C**N
these are very small thermistors but, quite accurate.
I set up a thermometer with the Arduino and these thermistors worked quite well. They are very small but, I had no problem wiring them up. The readings seem to be very much inline with the thermistor I was replacing, an MF52A which is a 10K thermistor. I got good results from these quite mini Thermistors!
D**.
Four Stars
Good very standard thermistors, easy to work with. Though the shipping is very slow (nearly a full month).
J**Y
Monoprice Mini Heated Bed Fix
Bought these to fix my son's Monoprice Mini 3d printer. The heated bed stopped working and after reading a forum on the Monoprice Mini these were recommended as the fix. After removing the bad heat sensor and soldering one of these on the bed now works and the temp setting and reading No longer fluctuates wildly and bed heats up like new.
T**L
Wrong sensor
Wrong sensor not enough info, trial and error next purchase worked fine.
S**U
It is kinda small sensore
It is work for xyz 3d printer.
J**Y
Great replacement part.
Needed to replace the cracked thermistor on my MP Select Mini. I removed the old one with some solder wick and then soldered this one on. I got silicone sealant but didn't need it. I was able to reuse the yellow kapton tape.
J**E
As advertised.
As advertised, but much smaller than I realized. Double check.
C**D
Five Stars
Great price.
J**Z
not 100K Ohm
8 out of 10 received were 75K Ohm, 2 out of 10 were around 85K Ohm. This is a cheap and not accurate thermistor. Goes directly back. Waste of postage..
Trustpilot
1 month ago
4 days ago