GLAZE N SEAL 'N - 173 Clear"Wet Look" WB er Gallon

I bought a few different sealers and tested them on my stacked stone. Most were like lacquer, smelled toxic, and left a glossy "thick" seal that, in my opinion, looked awful. But this stuff goes on like water, enhances the stone, no smell, cleans up with soap and water, and most importantly, you'd never know you were using a sealer. Whenever water hits it, it doesn't bead like the lacquer ones, but you know its working because the stone doesn't change color, it stays enhanced. To apply to the very uneven stack-stone surface, I needed to make sure to apply an even coat to all exposed stone but not get it on the surrounding cast-stone pieces. I tried different techniques using thick-nap rollers, a myriad of brushes, but finally settled on the following: I used an inexpensive, hand-held pump sprayer along with a sponge brush. Simply pour a pint of Glaze-n-Seal material into the sprayer, pump it to pressurize, then spray a small area. Use the sponge brush to re-distribute the material as needed. The sprayer delivers a fine, but accurate mist that can be controlled to not over-spray the surrounding area. Trust me, using this process will save you hours. I applied 2 coats; the first coat takes slightly more material because it soaks into the stone. I expect this treatment will last about 2-3 years in my area of Southern California where the weather is mild.

This product performed better than I expected. Was debating whether to use a lacquer sealer however I’m glad I used Glaze’N Seal. Wet look while preserving that natural stone finish. Used a sprayer to apply it, which was easy to apply and uniform application. You get your money’s worth for sure!

Keeps my stone bbq area looking fresh and vibrant. With all the elements of weather and use, this product beings my stone back to life.

I have been using Glaze N’ Seal for years. Dries quickly and leaves a nice wet look finish. You may have to use several coats depending on the porosity of the surface. The water base product has very little odor and is easy to clean up.

A wet look sealer should darken color and leave a glossy finish. After 3 coats, I have the glossy look, but the color remained unchanged. Not as expected.