Taylor Made Products Pontoon Boat Fender

This pontoon boat fender helps to protect our boat while launching, and we are easily able to tie it up with other boats without damaging the side rails and pontoons.

Fits great, and everyone that sees them wants to get a set

So far they are great. We attached ours to our Pontoon boat so we don't ever have to remember to throw the bumpers out and they aren't in the boat in the way all the time, Will be getting more for the other side!

Easy to attach but used a small ratchet strap instead of what was provided. The stayed on while going down the highway but noticed that I now took up the whole lane width wise. Don’t try to split tractor trailers lol. It totally beats pulling out the bumpers every time I come up on a dock.

The one had no straps with it. Looks like someone opened the wrapper & took strap. We bought 2 fenders so we know what we should have gotten.It is a good price. Would like all the product.

GREAT product if you can get over the high price for a squeeze of plastic. Of course, they are way cheaper than replacing a damaged pontoon or sidewall, so there's that.One of mine arrived a bit deflated, but I used an inexpensive basketball pump to inflate it and it's been fine since.Some notes about mounting:Each fender comes with two long webbing straps and instructions for mounting them in 3 different ways. Depending on your floor plan and furniture arrangement you might need to mount a couple of them one way and a couple another way, but between the three methods, you'll be able to make it work on most any pontoon boat.I have lots of seating on my pontoon and my sidewalls are pressed/glued tightly to the vertical posts so it wasn't feasible to use the hanging method. In my case I ended up attaching each fender by lacing the strap through the holes on each side of the fender, and then fastening the strap up underneath the deck.Hint : Be sure to mount them tightly so water spray doesn't dislodge them as you are cruising around.

This product came damaged. Huge bump on it that should not be there. Won’t lay correctly on the pontoon due to the bump. Just logged on to facilitate a return and my account says I missed the return window.

Bought 3 for my 26ft pontoon. When I pulled into the slip to the lake Gas Dock, the gas attendants had never seen these before and commented they were the best bumper guards they had ever seen used to protect the side of a pontoon boat!

Excellent product, easy to install, stays in place, even when tied up at the dock.

I've just installed it on my pontoon boat and it fit fine. It's much more convenient than hanging bumpers over the boat. You need to ensure you put the straps in tight, but you'll have to figure it out for yourself, as they don't provide much in the way of directions. The provide two straps, but I could only really use one on my boat.

It’s not what I expected. Poorly made. Would not recommend it to anybody.