24V 40W Cartridge Heater Thermistor NTC 100K 3950 Wire 1M for Ender 3 Ender 3 pro 3D Printer Accessories Eewolf

. Works great to heat up and manage temperature. Worked great with nylonKV, results may very, but I cycle the PID 50 times after adding the new specs of devices in to firmwhere.. I also love the cartridges types for heater and thermistor, easy to install and not having to worry about breaking the glass bead on you thermistor.

I am fairly new to the 3d printing world and managed to burn out the thermistor heating cartridge in my Ender. I purchased these as a replacement and easily wired up and installed one. It works perfectly! I’d say better than the original, but that’s probably more because I’ve learned how to print better. Either way, this did the trick for me!

You may need to solder an extension to use on the ender 3, and dont forget to recalibrate your printer to use the new thermistor. Other than that, great price!

The thermistors I received were an exact replacement for the stock Ender 3 hotend, and the pre-terminated wires were the same length as the original. Fixed my thermal runaway problem!

Plugged right in on my Ender 5. Works well.

I replaced my ender 5+ sensor and heater core with these, its worked so far. I've been printing at 235C for at least 50 hours total, 7-10 hours per print. You'll have to do some soldering.

I wanted to have some on hand in case I needed them. I haven't used or tested any of them, however I expect them to fit and work perfectly.

Works as intended get it of you need it.