10pcs 50 Ohm BNC Crimp Male Connector for RG58 RG142 LMR195 Cable

I was wanting to install both the female and the male fittings on RG400 coax.... Vendors seldom mention RG400. And going on the assumption that if it works for RG58 then it will work for RG400 is bad logic I'm told... HOWEVER... I installed both the male and the female units on RG400 and it worked great.... the collar fittings are a little tight over the back of the fitting but that's the way you want it to be... DO NOT crimp the little center pin... male or female version.... there's a little hole that will wick the solder into the hollow of the pin... this soldering is easy peasy... just get some really small diameter solder... soldering tip (really important) ..squeeze or bend the center pin a little bit so the center wire so it doesn't move around while you touch it with the soldering iron.. it doesn't take much solder... These are quality fittings and they work well on RG400

These BNC connectors are excellent! The crimp design makes installation quick and secure, and they provide a solid, reliable connection every time. Durable build quality and a great bulk pack for projects—highly recommend for RF and coax work

Decent enough quality. No complaints on them, just make sure you prep your coax appropriately

I have bought these several times, and they work good. The main use is antenna leads and patch cords for repaeters. They have been a good valve every time I reorder.

Great crimp connectors. Used for both cables and antennas.

I had to buy these because the center wire inside the RG-58 cable I got from the Brushbeater store was too large to fit into the center pins in the BNC ends that came with my crimped and stripper tool set. These work great.

Does not fit quality LMR 195 cable but they did work well for smaller coax cable

Ordered a pkg of these connectors to repair a damaged connector on RG 58 cable. I recommend practicing on an old length of cable, as it is VERY important to get the assembly and crimps correct. (YouTube videos are a great help.)If the connections aren't correctly done, the signal through the cable will be weak or non-existent. Also, be sure to check continuity after assembly, to double check that you've done it right. Continuity reading of 1 or less is ideal. These parts worked great & since there's 10 in the pkg, you have extra to practice on.

The quality is better than most on the market, ideal for Amateur Radio requirements for 50 ohm fast shipping and great seller

Good set of connectors. Easy to use.

These work as they're supposed to. You'll need a crimping tool to install properly, one that can crimp both the metal collar and the centre pin. Without one they are difficult to install properly.

The item was OK. Unfortunately, the seller uses Purolator for delivery. Purolator almost never delivers to an apartment (technically they can, but their drivers look for any excuse to drop off at a convenience store.)

Great product