New Rossi Small Frame Square Butt Revolver Grips Checkered Hardwood Handmade #Rsw09

Excellent product for price. Product needs some massaging to fit properly, but nothing the average person can accomplish. Overall, very happy with the product.

These are very nice looking grips for my Rossi 68, nice quality, and feel good in the hand, the only adjustments I had to make were putting holes on the inside without drilling through, for the pins at the bottom of the frame, I used a dremel, and using some black foamy stick on tape stuff to snug them up at the bottom, and top. Once I did that they were a great fit, and on tight with no movement, other than that I rounded the bottom part a little bit to my liking, and refinished them a different color.

Product did not fit the gun at all.I spent 3 hours fitting them where they would fit right.Product should be sold as a DIY project.They look great after you get them fitted but if you’re not willing to do that you’ll be disappointed.

I like the look and feel of the grips, but they will not fit on either side of two new Rossi revolvers I just acquired. The base pins in these guns are .250" in diameter, which is larger than those found on older Rossi revolvers (.230" dia). Enlarging the recess holes in the grips to accept the bigger pins won't work because the recess holes are misaligned with the revolver pin by an 1/8". I don't think the holes are misplaced. Instead, the rounded inside shoulders of the grip panels appear to be cut too high. They need to be lowered or ground down about .07" in order to fit inside the new Rossi frame. Out of curiosity I tried inserting the grips on an older Rossi revolver. The left panel snapped perfectly into place, but the right panel would not go on because the base pin was not properly aligned with the recess hole in the grip panel. I don't think this is the fault of the grip manufacturer. It appears the pin was not installed perpendicular in my old Rossi frame, but is slightly canted. Rather than fix the pin, apparently the manufacturer altered the grip panel hole to accept the canted pin! Therefore, if you own an older Rossi "square butt", you may be okay or can make it work, but I wouldn't recommend trying to modify these grips to fit the new Rossi revolvers from Braztech/Taurus.

Looks good. NOT EXACT FIT FROM PACKAGE. Needs some sanding and filing to fit. Also had to file the top strap to get the hammer to lock. Screw is soft brass. Be careful screwing in and out. You WILL strip the head slot.

very good.

They Fit pretty well on my revolver brass screw is a bit delicate so make sure to use the right size screw driver and one grip is ever slightly bigger but can easily be fixed with a lighting sanding feels great in the hand to have a much better grip on my Snub Nose rossi

Grips are a lot lighter in color than what the picture would lead you to believe. Not bad on the grips not perfectly even or level and doesn't necessarily close all the way up but they're not terrible I just wish to have been a little closer to the picture for the color.