warmiplanet Flush Mount Ceiling Fans with Lights and Remote Control, 52-Inch,3 CCT Dimmable Light, Reversible Noiseless 6 Speeds DC Motor, Timer, Brushed Nickel, 3-Blades

This fan is very contemporary looking. Looks great and appears well made. As fans go, pretty Easy to install. I’m a 69 year old woman and installed it all by myself. Took a couple of hours because I had to take a lot of breaks as my neck was killing me. Also, the directions are not very detailed but between the pictures and the few words and contemplation, it finally made sense. A magnetic screwdriver is very helpful so you don’t loose any screws. The hardest part was installing the blades, as lining up the holes was very trying. Thankfully, there are only three blades.The fan is absolutely quiet on all three speeds. The light will totally light up your room - it’s the brightest fan light I’ve ever seen. Too bright and garish, really, but if you hold the light button, it will dim as much as you like. There’s no bulb though, just a bunch of led lights on a plate, so I’m not sure how one would replace it if it failed.The only downside is that it is operable only with the remote and remotes often get lost around my house (grandkids). I’m going to try to order a second remote just to have as a back up.Overall, I really like the fan. Great bright light and super quiet running. No wobbling and no blade balancers needed. And i’s very attractive. I hope it lasts!

My FL room’s ceiling is lower than the rest of my house’s ceilings and these fans, beside being high tech, are sleek looking, made my FL room look neat and modern.

As some have stated, this doesn't move a lot of air. If you have a large room, you might want another fan. I have this in a small 10 x 11 room and the speeds are perfect. 1 and 2 will keep a gentle breeze moving and speed 3 ramps up to get some wind. I prefer ball-mount fans. This one has a hook. This also requires two screws around the outside edge to be left partially screwed in and two to be taken completely out. It's a bit of a pain to try to hang on the two screws and also keep the washers on the outside of the housing. There are some pieces that have to be manually put together, however it was all relatively simple. The blades slid into the housing through slots. I thought this would be a problem since it appeared there was some wiggle room. I thought the screws would be hard to thread because the blade could move around. This was not the case. Each blade slid perfectly in place and I was able to find all screw holes the first time. I didn't have any trouble with my remote. If you want to change the brightness, you have to press and hold the light button. It seems that you have to press and hold, then release, then press and hold again for it to understand what you want to do. If the light is on and then you press the light button and hold, it doesn't respond the first time. I think this may be some people's frustration thinking they have to press the button hard. That's not the case. The buttons all work with a short easy press.. I wish the motor could be reversed from the remote instead of the switch on the side of the motor, but most fans are like that, so I can't fault it for that.

I was skeptical at first, especially of only 3 blades. But I liked the looks of it so I thought I’d give it a try. This fan lives up to its advertising: it’s beautiful, it’s quiet, and it’s relatively easy to install. The remote makes it easy to control while you’re in bed, and it does a great job with air circulation.My only real complaint is that you can ONLY control the fan & lights from the remote. The wall switch will let you turn the device on or off, but that’s it. If you turn it off at the switch, the remote becomes useless unless you turn it on again at the switch. If you turn it on at the switch, you’ll get the fan and light settings that were last used, but you’ll still have to grab the remote if you want to make changes. Sorry if it sounds like I’m mansplaining this, but it never occurred to me that where my bedside table is located (where the remote stays), which requires me to enter the room and walk around the bed to turn the overhead light on, would become so annoying!OK, rant completed! I’m probably just a picky old man anyway, and I’m sure I’ll get used to it. But the truth remains that it’s a very quiet, stable, and attractive device that circulates are better than any fan I’ve ever owned. Glad I bought it, and the price is good as well. I know looks can be deceiving, but it looks like it could run nonstop for far more years than I have left to use it!

Love the handsome look and compact design for low ceilings; it's quiet with good air breeze. The receiver is already pre-installed! Light kit is pre-assembled & located under the installed receiver, so that wires needed for connecting to a wall switch are not accessible. That's where I wish it were a bit different - the only option for controlling is via the remote as far as I could determine. I'd hoped to have access to wires controlling light, but alas, they are not accessible.For the DIYer whether installing where there is no ceiling box or replacing a light fixture, this installation is easy. I love that it has a hook so you can hang the motor from the ceiling while wiring connections are made so it's actually a one-person job.

The media could not be loaded.  Functional, silent, aesthetic, and powerful. That's why I continue to choose Warmiplanet ceiling fans, because of their great quality.

Setup was a little time consuming, but extremely easy to follow instructions and I love they installed a hook to hang the heavy motor frome while you're wiring the fan to the house wires.It looks amazing and I love the black ⚫️ It gives a nice off set to the room.

This was the easiest install of a ceiling fan I’d ever seen. The fan is solid and well balanced. Love the dimmable light. Pretty darn quiet for a fan in this price range. Buying another one for the bedroom!

Tengo un año con este abanico, muy nice elegante y de calidad. Tiene tres velocidades, incluye un control de RF para controlarlo a distancia. (Si lo deseas puedes integrarle un controlador wifi fácilmente como el sonoff fan01) tiene luz cálida con ajuste de intensidad. Muy recomendable. Cero ruido en las primeras dos velocidades y muy poco ruido en la velocidad más alta.

Fácil instalación. Se ve genial si quieres un acabado industrial o incluso mínima lista. Trae 2 acabados en las aspas, níquel y como madera. Hasta el momento funciona sin problemas, nada de ruido. En donde vivo hay 40 grados Celsius la mayor parte del año, y hasta ahorita sirve genial.

Me encanta!! Muy bonito diseño, moderno, refresca muy bien una habitación pequeña, muy buena lluminacion y calidad de sus materiales. Lo único que le puedo argumentar: no trae instrucciones de armado en español. No estaría mal si agregaran un tutorial para armado 😉 Lo compraré nuevamente

Todo bien excepto un poco de ruido. Muy bonito y ahora el ruido esta arreglando