FSSWH1502 Digital Programmable LED Touchscreen Wall Heater for Home or Commercial Use, 1500 Watt, 120 Volt, Medium, Gray

I purchased two of these 120v heaters to replace early 1970's/late 60's era electric heaters in a finished 450 sq ft basement. Fortunately the wattage draw matched the heaters being replaced and each had a dedicated 20amp breaker. These were from Amazon Warehouse deals and were in like new condition -- unboxed but didn't appear to have ever been installed (yes! -- nice, budget-friendly savings). Installation was easy and both work as advertised. The remotes are a nice addition, but are limited to off/on and increase/decrease heat. Of note, the heat comes out the bottom third of the heater. In tandem, these produce enough heat to keep a 450 sq foot room warm (7 1/2-ft ceilings) and they look GREAT; kind of high end modern which I was looking for. Programming is tedious, if you go that route. And, if these were wifi-enabled (but they're not), well that would be awesome. Fan speed is based on target temp, lower temps seem to have a lower speed, while setting the temp higher increase fan speed. Overall these are nicely engineered, work as advertised, and are, in my opinion, aesthetically pleasing compared to many alternatives.

The heater was received in excellent condition and installed easily. My only wish is that it was 1/2 inch less deep to fit exterior walls

Like it but hard to use on off buttons

The media could not be loaded. Edit: I’m a dumba** and hooked a 120v heater to a 220v line.Turned the heater on There was a loud pop and I started smelling smoke. The heater caught on fire around the circuit board and thankfully I was able to spray the fire extinguisher to put it out. I’m trying to figure out who to contact.

Installed in a cabin bathroom that does not have any other heating. It works great and quickly after setting temperature. It heats the bathroom in just a couple minutes and turns itself off if you forget to turn off. The remote can be kept by the bedside and turned off before you get out of bed. It really cranks out the heat in the 8x6 space.

Really cool looking and operating heater.unfortunately every time we turned it off, the next time we had to switch it back on and hit mode button before the remote would work.This made it impractical for basic remote operation but makes sense for safety reasons.More practical for continuous on maintained room temp operation than occasional remote operation.(why have a remote if you have to go set it anyway).

I love this heater. Works great to hear a 18x8 room. Programming makes it easy. It is a bit louder than my other heaters, but does the job and the ability to program it is wonderful.

I purchased this heater to install in a high end bath remodel. It looks very modern and fit the style in that respect. The heater makes a loud ticking noise when the heating element comes on. It sounds as if the fan is hitting something, but I have checked and it isn't. The fan will run on start up or cool down mode very quietly. I spoke with Marley technical support and they sent me the circuit board to replace(huge pain and shouldn't be done by the consumer). They said that a relay switch was making the noise. This did not fix the problem. Now they have sent me a new control panel to replace(hopefully easier to replace). I will replace the part tomorrow, but I am skeptical as to whether this will fix the problem. I may have to buy a new heater to get the final payment for the job, however any other heater probably won't match the size.

The main problem with the product was the shipping. 2 packages arrived ok. the third was destroyed. Amazon along with the manufacturer did a great job at replacing the smashed heater. The replacement heater arrived and also had a damaged box. However, the heater was intact but had several missing parts because of the way they are stored at the top of the container allowing the items to come out of the damaged box. Again, the manufacturer replaced the missing parts.When all was said and done, the heaters work very well.