Gen 4 Hybrid NVG Battery Case & Counterweight Pouch + Cable Management System for Tactical Helmets

Fit, extra support strap secures front, satisfied with functionality

This is a nearly exact duplicate of the Agilite helmet "bridge." However, this one comes as a kit with 1 main and two smaller fabric pieces, two plastic pieces with 2 holes, and a small elastic cord. The two smaller fabric pieces are your crosspieces and you use one or the other depending on the size of your helmet.Let's start at the beginning:1. If the crosspieces are attached to the main bridge, take them off and set them aside.2. Starting at the front loop - which is the narrow part of the main piece. (up in the first photo), put the cord through it evenly on each side.3. Thread bod sides of the cord straight back into the first plastic piece.4. Continue threading straight back to the first pair of side loops then into the second plastic piece.5. Continue threading straight back to the next pair of side loops.6. Come back from the side loops and pass both sides of the cord through the center back loop (second photo) under the flap.7. There is one final loop all the way at the back of the bridge. Again, without crossing, pass the left cord left to right and the right cord right to left through this loop then run them through the spring-loaded lock then tie them together near the end of the cord. Make sure this knot is tight.8. The two Velcro fabric pieces are your optional crosspieces which go from ear to ear. You only use one of them, depending on the size of your helmet. You will note that near the front of the center piece that you just threaded the cords through, the top and bottom layers can be pulled apart. After mounting the bridge on your helmet, separate the top and bottom and slide the correct length crosspiece through it and attach to the Velcro just above the ears on each side.Note: The cords never should cross each other!

Came without retention cord for my strobe ect cord is completely missing. Battery holders are to lose to hold AA or 123 batteries. Does hold a pvs31a’s battery pack fine. Velcro remains in place on helmet 90% of the time battery pack section peels off at the sides.

Agilites is better and cheaper or around the same price as this.Better and original project.