Ball Joint Boot Kit, (78-95)

I installed a lower control on my 2013 Dodge Grand Caravan. When I was installing it I accidentally poked a hole in the ball joint boot. I ordered this due to the reviews and the sizes seemed to be a good fit if I stretched it just a little bit. My ball joint pin size measured between 16mm - 18mm depending where it was measured. The bottom of the ball joint on my car measured 39mm. The pin side of the boot fit perfect. The bottom had to be stretched just a tiny bit but it fit great. The height does not matter as long as it seals the ball joint. The clips as others have said are a pain but that is the nature of these kind of clips. The top clip can just be left on when installing but not the lower clip. I used needle nose vise grips to hold it open when installing. It seems to be made of a very high quality rubber and much better than the original. This sale is for just 1 boot and most companies sell a 2 pack but I would buy this brand again no matter how much I would save on the 2 packs.

Road debris ripped the front lower ball joint boot on my 2002 BMW E46. To replace that ball joint requires replacing the entire lower control arm.The Rennbay boot work great as a replacement boot.

Exactly what i was looking for. Installed on '17 Chrysler 200 lower ball joint. I didnt measure beford i installed but my original was 19mm and 38mm. Eliminate small clip but the large clip worked fine. Thanks

Fits upper ball joint on Porsche 928s with a little work. I know its not listed as fitting, and it does not fit perfectly, but it is close enough to work and hold the grease in and has not failed on me in almost two years now. Also cheaper than the actual oem 928 boot.

Perfect to seal ball joint - was still tight. I have their 944 control arm repair kit in stock also so that I can repair the ball joint when I need to.

Perfect

IT FIT FIND FOR A GREAT PRICE. ITS ON THE CAR NOW AND WORKING GREAT.KEEP UP THE GOOD WORK.THANKS OK