Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(Warm White), Power Adapter not Included

High quality

I purchased these to install under a homemade cabinet. These have only been used indoors so I cannot speak to their IP rating or their UV resistance as others have noted there may be concerns in those areas. For my application, they work perfectly. They were easy to install and soldering wire connections to a switch and 9V battery was simple. The adhesive was a bit lacking when applied to the pine cabinet surface, but I did not intend to use the adhesive alone and used mounting staples to keep them in place. If you are relying on the adhesive alone to hold these you may run into some frustration unless you have a smooth surface and install them on long straight runs. For my application this was not an issue, since I was using mechanical fasteners. Brightness running off a 9V battery was exactly what I was looking for - not bright enough to add accent in full sunlight or a brightly lit room, but for little to no ambient light (which is what my application is) they are perfect.

So I recently purchased a roll of these LEDs, as well as the Cool White 12V version. My project was to wire my new Matco Service Cart with blue LEDs underneath and white LEDs under the lid, wired to a magnetic switch on the N/O circuit. You open the lid, the magnets come apart, circuit closes, and the lights turn on. Close the lid, bye bye lights. Got all the wiring cut and crimped and tucked away nice and neat, and then attached the LEDs to their positions after wiping the surfaces down with mild soap, then water, then dry wipe. Whites have been up inside the lid since I put them there, not a single issue, but the blue... Well, they were all over the floor the morning after first install. I ran over half the strip with my cart's wheel before I noticed, destroying a large portion of them. Cut a new line from the remainder of the roll, and encountered the same thing later in the day... blue LEDs drooping and coming off the cart. I'll probably order another roll and just see if I got some poor glue in a batch, or what the case may be. Aside from that issue, the lights seem real sturdy, plenty flexible, certainly bright enough and they throw a nice indirect glow. Wiring them into their little connectors is troublesome, so I ended up soldering leads together when I had to, simpler that way for me. All in all, I'd recommend 'em if you're looking for some kind of lighty project.

This product is inexpensive but worth the cost. The adhesion tape is not the best however if mounting on the underside of a wood deck railing or stair nose a low powered mechanical staple gun using t-50 staples spans the lights perfectly. (5/16 staples every 12" finished with a small tack hammer) I installed these lights and hardwired directly into the 12volt landscape transformer so they come on with the other lighting. This was an experimental purchase that just worked out so I purchased more. They provide couplers for longer runs without noticeable spaces. It is best to clean the mounting area with rubbing alcohol, make sure surface is dry.

Worked well. Gives lots of light. Easy to connect to po

SOOO Disappointed! I rebuilt our custom beach wagon adding these lights as underlighting around the underside. 3 days of custom fitting and securing with LED holders, testing as I went. Worked great until I went to do a demo video, and a third of the strip just quit! The lights hadn't even been used for a total of 10 minutes!! Now what?? I have to dissamble the whole underside and start over. The motion part of the lights work great except for the third of the strip that is dark...

Lights are amazing but the adhesive not good at all. I cleaned my metal surface with alcohol before applying and next day some areas started to fall.

This LED strip was just what I needed to brighten up the area inside and under my camper cabinets. I bought the soft white strip and am very pleased. The light strip is covered with a clear silicon rubber that makes the entire string very flexible, durable, and waterproof. Safe places to cut the strip are marked on the strip, making it easy to cut to length. Any length can be cut, as long as you cut where indicated. I cut three lengths to install in/under my cabinets. I cleaned off the clear silicon rubber covering to expose the solder pads with an exacto knife and easily soldered wires to the strip. The power and ground wires can be soldered to any set of pads anywhere along the string and it will power the entire string. Make sure to make the proper pos and neg connections, as LEDs are sensitive to polarity. Polarity is marked on the strip. The adhesive back sticks very well to a smooth surface. Very low current draw. Perfect for my installation. I have plenty left over and am looking for other places to use it!

As luzes são brancas mornas, mas do tipo quase branco, não amareladas. Achei muito fracas. São impressões minhas. Eu fiquei decepcionado. Funcionam, não se trata de uma reclamação.

Lights are nice and bright! Easy to install

Nice bright LED lights but shouldn't be marketed as warm light. These are definitely more of a cool white light.

Very frustrating to fit this strip in my kitchen and find it looks like it's more suited to be for surgery with such cold lighting. Don't buy it.

Love the orange color. Reminds me of the 90s aesthetics. Really cool.