inShareplus LED Aluminum Channel System, 3.3ft/1 Meter, 20 Pack, Silver, U Shape with Milk White Cover, End Caps and Mounting Clips, Aluminum Profile for LED Strip Light Installation

The aluminium was easy to bend, I used a medium saucepan as a jig. Easy to cut and file.There were no joing bits in parcel, I used the holding clips at each joint, so half the clip had one piece and the other half has the other piece.The plastic cover was easy to cut and went on without much trouble, as you can see my bends are gradual.Downside, I used all the fixing clips for just this job, I have another three lengths not used, will see if CT1 will hold them into place for the next job.Clips are a but fiddly to install, pilot hole first.Giving it 5 starts, £30 for six lengths of aluminium posted to my door, what's to complain about.

Great for the LED ceiling corner light

There were supposed to be 10 x 1m strips however it only arrived with 9. Thankfully I didn’t need 10.Installing these isn’t easy. Getting the plastic diffuser strips into the aluminium channels is very hard and there is definitely a knack to it. I found pinching the diffuser strip slightly to get it into the aluminium channel was the easiest way. Then applying very accurate even pressure to the diffuser strip millimetre by millimetre, slowly. I eventually got the strips in.

Looks really neat when finished but you can still see each pixel through the white plastic, not opaque enough. The only way to make it look like one complete tube is if you have very close LEDs and turn them to full.Still a good product but a little expensive.

The package was open and fixing were missing.The product itself feels good quality. Lids are a bit hard to get on, they don’t clip in easily or slide in easy either, but with a bit of will power got them on

This pack had all the parts required to link I up a seamless strip around my room. iMO good quality aluminium and plastic parts which were easy to cut down where required and light enough to go up with double sided Foam tape. Would buy again.

Thin enough to be low profile very flexible

Very good item, simple to use and holds the lights in place very secure, could do with a few more clips but can make do with the allotted amount, arrived secure and well packed and on time!

These are great . I was worried they would not be malleable but they really are and easy to install.Govee products are great for teenage computer set ups

I’ve never written a review for a product before, and I am only writing this to prevent others making the same incorrect purchase. I purchased 2 packs of these diffusers to eliminate the hot spots on my led strips, hoping for a smooth beam of light as shown in the product photos, I didn’t receive the results this product showed. Instead of diffusing the hot spots and smoothing the light pattern all these did was make the hot spots slightly blurry and you can still easily see each individual LED. Due to the product not coming with corner pieces or selling corners at all you need to cut the aluminium backing plate and diffuser strip with a hacksaw at 45 degree angles. Unless you want to spend £5 per meter on proper LED diffuser strips, You are much better off backlighting (facing the leds towards the wall to achieve a smooth glow) whatever you’re installing on as these strips, I’m sorry to say, honestly look bad, I have attached photos to show the actual results, this is what it looks like in person not just on camera.

Works great for led lighting strips

Ok but would try other brands next time , not enough fixing clips and no end plugs to finish off

Good led light holders

Easy to fit, only issue was end caps, as they are plastic there is no margin for error, if they were rubber the push fit would be more practical.

Nice durable and not too thick, perfect for LED strips