200 Pairs 2.54mm 18-24awg Male and Female Pin Jumper Wire Cable Connectors

Good quality, good positive contacts. Crimp and solder well.

They're okay but they tend to be a little short. Make sure the pin header your plugging them into is a little long.

Not much to say about this simple product. Finally got around to needing to make a stepper motor to driver board connector and the 4-pin plug fit snugly.

well made, no burrs; sometimes noticeably different insert/separation forces. am using them on short wires soldered to sensors to connect them to a permanent wire harness. sometimes crimped, sometimes soldered; they take 63/37 rosin solder very easily.

These are very short (10mm) and just barely fit in my crimper; there is no wiggle room and often get miss-crimped and destroyed. They are also made from a very soft metal. This makes them hard to remove from the strip they are attached to and also the wire is easily pulled out after crimping.

Pins and socket inserts for Dupont style cables as used in Arduino, and other projects. So far all of them have worked perfectly. If you need it, get this one. It's good.

These pins were a good fit, I simply added a wire so I could connect a Meter or inject a signal. Worked fine and did not harm the connector.

Work o.k. Not as stiff as what I am use to, making it hard to keep them in the crimper.