CLC Custom LeatherCraft 1528 Large Electrical and Maintenance Tool Carrier, Black

Perfect and handy little work tool bag . Compact light and easy to carry around .

Excelente calidad de los materiales, un poco reducida en los compartimientos centrales. Muy recomendable!!!... se puede guardar hasta el taladro.

Excellent bag, highly recommended

I took a long time looking around for the right tool carrier for my new wood turning hobby and this electrician's tote turned out to be exactly what I needed. Because I started off turning wooden pens and lots of small parts are required, the storage tray tray hidden in the base of the bag comes in very handy for keeping bushings, brass tubes, spare parts, etc. organized and readily available. Plenty of pockets, zippered compartments, nooks and crannies are very satisfying if you're the kind of guy who likes to keep your stuff conveniently located as well as portable. Besides loving this tool carrier, I am writing this review because there is a tip I want to share that has to do with the condition the item arrived in when Amazon shipped it. You'll notice in the pictures of this tool carrier the handle flaps stand straight up and down. They are in fact pretty rigid and designed to stand up out of the way of the storage on either sides of the tote. Unfortunately, when mine arrived it had been packed in a box that required the handle flaps to be pushed down to one side. As a consequence, the flaps would not stand up even when I loaded the bag up and suspended it over night in an effort to get them to straighten out. This may not seem like a big issue but I found with the flaps bent to one side, I was having a hard time getting to items stored on that side of the carrier. After a few weeks of this and nearly on the verge of deciding to return the tote, I came up with a solution. I figured there had to be some kind of a plastic insert inside those flaps keeping them rigid so if I could heat them up a little I might be able to straighten them out. I took a small hair dryer my girlfriend leaves at my house and used this to warm up the flaps while the bag was suspended. I moved the hair dryer around a lot to keep from burning the canvas covering and I worked on both sides of each flap alternating back and forth. After about 5 minutes of this the annoying curvature in the flaps relaxed and my tool carrier now looks like the one in the picture. I left the carrier hanging up overnight and there hasn't been any relapse into the bent position. Go ahead and order this nifty tool carrier if you think it will suit your needs and if you run into the same problem I did just pull out a hair dryer and in 5 minutes or so, it will be like you bought it off the shelf at your local hardware store.

Brilliant service will use again