50Pcs Metal Library Label Holders, File Cabinet Label Frames with Screws, Card Tag Label Holder for Office Drawers Shelves (Antique Bronze, 60x17mm)

These name holders made our staff mailboxes look neat. We were previously using stickers, which were a nightmare to update as staff moved in and out. My names are on card stock and it is super easy to load the tags into the holders. The screws that come with the order make the holders sturdy. I can recommend this item.

Used them on canvas totes on my closet since drawer space is at a minimum , attached with E7000 glue and look super cute and now I can tell what’s in them from a glance

The title of my review doesn't seem to indicate anything good, but it actually was. These did look kind of cheap and flimsy when you first take them out of the packaging, but once they're installed, they look a lot better. It isn't antique quality or anything, but for the price, this was exactly what I was expecting. They look decent, and do their job. I am very pleased with my purchase.

These were great to finish cabinet built from scratch

These worked just fine for labeling a key rack. Look good.

Works fine

Great quality, and they do what they're supposed to. The label slide is a bit wide though, which is good because it makes it easy to slide labels in and out, but bad when you have them on things like books, because they fall out, so I just used a piece of chip board instead of paper, and it works great!

These are what you would expect for the money. Not super thick but they are fine. Here are some installation tips:1) Clear the room of children, there will be swearing.2) Put a towel under where you are working so when the tiny screws fall to the ground, and they will, you can just shake out the towel.3) Don’t skip drilling pilot holes, the screws are so small, it’s easier if you can push them into a hole. You will need a tiny drill bit or nail scissors or a sharp narrow awl. Use the thumb of your opposite hand to steady the bottom of the screw when you screw it in.4) Use a weak tacky tape - like masking tape - to hold your placement. Be sure to adjust and check after your first hole.5) If you are using a label maker, the .47 12mm size will leave a gap. Either get a bigger size or peel back the top sticky part so you can place it on the surface. Don’t peel the bottom, it will get stuck before you place it. Alternatively, it would also be easy to use file tabs, like the ones that go on hanging files, they are the right width.