Re-Grip PN44-7 Replacement Handle Grip for Hand and Garden Tools, 0.69 by 1.5-Inch

Broke a factory shovel handle that had factory applied grip. Replacement handle didn't so purchased and added this. Excellent grip and not really hard to apply. Will purchase as I need for other handles that could use added grip.

I needed a grip for my pull-up bar and this product is perfect for it. The medium one fit nicely into the 1.10" bar... non slip, cushion, rigid, and looks very nice. The installation was a breeze... With a sharp razor blade, trimming off the excess is easy, but cutting a clean, nice edge wasn't that easy. It was about half inch longer after installed... So, you should start where a clean edge is desired. Despite the instruction, I lined up the grip so that the imprinted arrows pointed toward the middle of the bar, then slowly pulled the yellow plastic coil following the arrow direction while keeping the grip's edge flushing with the bar's edge... Very professional looking result!

I debated spending the money on two of these for my wheelbarrow but man were they a breeze to put on. They fit perfectly and I had both in in under a minute. I've any reviews complaining about trouble installing them. A two year old could do this. And they seem to be good quality. Now at least I won't get splinters from those old handles. 🙂

Bought these grips for strait edge handles to pull concrete two years ago they are still brand new..

Hammer handles are mostly oval, my hammer handle is not a curved axe type but straight. since the handle is slightly bigger than the medium size product max handle diameter i had to use a firm push to make it go on, so it should be extra tight. but its loose, un usable loose. so unless you have a perfectly round handle of the max diameter dont waste your money .