The 6mm Bore XL Series (1/5 pitch) Pinion Pulleys can attach directly to any of our gearmotors that have a 6mm output shaft. Simply slide the pulley onto the motor shaft and tighten the 10-32 set screw, using a 3/32 hex key. The pulleys are .40” inside the flanges to allow for belts up to 3/8” in width. The 10 and 16 tooth pulleys are able to run inside of the aluminum Actobotics channel. The pulley can be used for building pan and tilt systems, camera sliders, XY tables, robotic drive mechanisms, etc. Constructed of 6061 T6 aluminum. The 1/4” Bore (#615376 & #615378) XL Series (1/5 pitch) Pinion Pulley can attach directly to our 1/4” shafts. Simply slide the pulley onto the shaft and tighten the 10-32 set screw, using a 3/32 hex key. The 16 tooth pulley is able to run inside of the aluminum Actobotics channel. The pulley can be used for building pan and tilt systems, camera sliders, XY tables, robotic drive mechanisms, etc. Constructed of 6061 T6 aluminum.
M**F
Set screws constantly back out. Had to put thread ...
Set screws constantly back out. Had to put thread lock on them to stay put. I've never had to thread lock such a small gear before.
Trustpilot
5 days ago
1 month ago