Just Clips (JJCP135) Snap Ring Tool Kit

May be expensive but these units work great and you will not have to get rid of an old tool that will not hold a socket etc. I have asked many tool stores about get the clip ring replaced and fought a wore out one many times. Tool stores said not fixable. Bull !! They just wanted to sell another tool. Replacement clips are spendy but I bet you have a friend or two that could use to have there tool repaired and if you have them chip in a few bucks you will pay for this tool soon.

Sockets can fall off after the clip on the anvil is worn out, and with this kit you can keep using the old ugg dutta, because you've maintained it with ample grease and everyday oil as well as the after work buzzer has rang with a bit of the spittoon polish. It's easy too, yank the old worn ring, clean anvil, file with the supplied sticky-backed emory sand pad, clean again with solvent, get new ring and backer push anvil into press and voila, just like the day the stealership tool truck pulled up and knew your wife wouldn't mind some new work toys. Only downside at all is that the supplied amount of clips for 3/8" and 1/2" are only three of each, so make sure to exchange the clips in private. You know 'Ol frank, and his borrowing habits. Hell, buy frank one too.

Not a lot of ring included, but bought for the tools. The pliers, and ring instalation plate is a real time saver. Though the o ring pick is pretty useless.

No dislikes saves my company money and time verses tapping the socket head to keep the socket on the impact

tool works very good

excellent kit, with lots of rings.

As advertised and then some!

👍🏻