Grohtherm 1000 2-Handle Thermostatic Shower Valve Trim

Good quality.

It's super :)

Replaced an old single-handle Moen valve in a stall shower with this. Needed to do quite a bit of carpentry to make it work. The plumbing part was easy, however, because of Pex and Sharkbite fittings. The valve works very well. See pictures. No stars removed because of the extra work, as I knew going in what was needed.Update: Very pleased with this valve. MUCH easier to regulate temperature than the single-handle valves I've seen, which are much more common in the US. Definitely worth the work to install it.It's easy to reset the temperature where the "stop" is; just remove the knob - first take out the chromed insert and remove the screw - and rotate the valve stem until the temperature suits you. Then replace the knob without moving the valve stem. You can always press the button and rotate the knob to make it hotter. Remove the red insert inside the knob if you want it still hotter when you press the button to go past the stop.Similarly, the flow control stop point can be adjusted by removing the flow knob (the right-hand knob) and replacing it in a different position. It will shut-off "off-center" but this is not a bother to any of us here. Pressing the button and turning the knob further increases the flow to the maximum, no matter where you replace the knob.

Smooth operation.

Comme remplacement de robinet de douche thermostatique, c'est parfait! J'avais un de marque GROHE avant et je ne regrette pas du tout de continuer avec cette compagnie dont les produits, jusqu'à maintenant, sont très fiables.