Kensington SmartFit® Space Saving Single Monitor Arm (K55512WW)

So first off - I have been searching a long time for a 'low profile stand' that would minimize my footprint on my standing desk and allow me to cross the gap on my desk against my wall.THIS stand did it and more! Easy to install - took about 15 minutes to install and mount both my monitors using the included plate and screws. I have two monitors stands and they rock!For me the 'lack' of movement in this case 5 degree swivel left to right is just barely enough - I actually require about between 7 and 10 degrees my solution was to simply turn the base of the stand ever so slightly - that required that I did NOT push the stand completely flush with the desk. It’s still extremely secure. That said, while the stand does come with an upper felt strip to cover the top of bottom of the mounts portion of the stand, out ot concern for my new walnut desk I installed felt strips (not included) on a portion of the metal to minimize the scratching.Other that the minimal angle adjustment / swivel left to right adjustment I had to made, the vertical adjustment worked just fine for me. If you are looking for a simple stand that allows you to butt up your desk super close the wall and you don't have a need to always be adjusting your monitors THIS is the stand you should get. The vertical adjustment while manual is done via the large wheel which is super easy to adjust when needed.Bottom line if you need space both against your wall and on your desktop - grab this you won't be disappointed as it just works!

The stand is very sturdy and helps save space on my desk compared to other monitor mounts that I've tried. Keep in mind that you will need some space behind the desk as well when this stand is mounted.

I was looking for the most compact mout for my 34" monitor as I didn't want to use wall bracket.Had a straight pole mount before but there were few cm wasted space between it and the wall.This unit due to its bent base sits closer to the wall, as close as it can physically bez really.It's has nice cable holders to keep it tidy and easy to operate "helm" well for adjustment - unlike other products which require Allen key yoga.The only downside for me is the fact you cannot remove/replace the tilt/pan mount for even flusher fit, it would save me additional 2cm, but it's fine as is.It's much better than those double arm adjustable monstrosities if you just want a simple replacement for monitors own stand to maximise desk space.The description wasn't clear but.thenproeuct comes with clamp and the grommet mount.

The stand look super nice and it’s the perfect match if you like me bought an IKEA KARLBY (because of its nice design) and can’t get used to it being narrow

La placa VESA que se atornilla al monitor se encaja en el brazo con holgura. Esto hace que al ajustar el monitor, tanto de arriba a abajo como de izquierda a derecha, no sea un movimiento suave y continuo sino saltos bruscos. Acabé colocándole al monitor el pie con el que venía.