OVERTUREPETG Filament, PETG 3D Printer Filament, 1kg Paper Spool (2.2lbs), 1.75mm, 3D Printer Consumables, Dimensional Accuracy +/- 0.05mm, Fit Most FDM Printer

Almost perfect match for Ryobi green. Even right next to a tool, it's hard to tell the difference, and it could be because my tool is old and faded.Prints like PETG, which prints well for me. I did have a couple failures at first, which was unusual, but that was also right after I printed some PC, had leftover glue, and had the wrong temps, so probably user error, not the filament. Who knew that PETG smelled like PLA if you print it at PC temps? lololol

Ordered this filament specifically to make tool hangers for some Ryobi tools - the color is a near perfect match to Ryobi green. The filament itself is good quality for the price, easy enough to print.

First of all this is my worst experience with a filament ever, I don't know if its this specific color, it has the absolute wose adhesive ever, I have to lower the z offset a lot to press it hard on the pei sheet.Secondly, I am strongly questioning the actual weight of the filament, I did a print job estimate 360g of filament, and accroding to the spool I have 400g of filament let, so it should be good right? No it doesn't, the filament run out at about 70%? Of the job and I end up with a usless junk. So either the lable needs to be changed or they aren't 1kg of this thing at all.

This filament has the worst layer adhesion I've ever seen. Ok for small prints but frequently had extrusion issues because of contaminants and frequently would have supports fall off mid print.

I have tried a bunch of different temps and speeds. I keep getting random spots where the filament will not stick to its self, I Believe it is the color other colors don't have this issue.