Question 1

Would this product work to attach an accent piece (cast stone) to porcelain tile?

Accepted Answer

The porcelain tile yes the cast stone you can try but I don't think so.

Question 2

Would this product work to glue a shower rod to ceramic tile?

Accepted Answer

If you are talking about gluing the rod holder ring to the tile it will most likely work.  It has good holding strength.  It would be enough to hold up the curtain but if you tug on it it might eventually have to be done again.  I would take the holder and put enough on the ring the holder goes ins' back so that when the ring is pressed in place that a bead approximately 1/8 inch is forced out around the ring then tape in place and leave for a minimum of 24-48 hours before any pressure is placed on ring.  This should hold for a good while.  Also what will work just about as well is if you have a hot glue gun with clear glue to do the same  thing except the glue you don't have to wait for more than an hour.  then if after a while the ring falls off don't remove the old glue just put another coat on and repeat. If either method fails try roughing up the tile surface where the ring mounts to knock the shine off and try again.  The Hot Glue or adhesive will bond better to a dull surface over a shinny surface. The glue gun if you choose that method has to be a Hot Glue gun not a little craft glue gun.  Either method may eventually fail  but will last longer if you can find a little piece of foam or something to place at the end of the rod so that minimal pressure is being pushed against the tile both horizontal to compensate and reduce the vertical tension. This will make either bond last almost indefinitely.  When these bonds fail they are usually because of a jerking like grabbing the curtain or a combination of vertical with horizontal sheer so if you can reduce the vertical by placing a little horizontal pressure the bond lasts longer.

Question 3

what is color?

Accepted Answer

Tanneous white. Does not look good exposed.

Question 4

Does this require a caulking gun?

Accepted Answer

If you buy the cartridge as shown in the image, then yes it does require a caulking gun. It may be sold in a plastic tube that you can squeeze out for small jobs, but if you are going to do caulking then you need to have a  caulking gun. They are relatively inexpensive and I would recommend getting two--one for caulk and one for glue--because you will end up using both most of the time.

Brand	Loctite
Specific Uses For Product	Bathroom, Renovation, Repair
Material	Wood
Item Form	Liquid
Special Feature	Repositionable,Waterproof
Color	Plain
Item Package Quantity	1
Package Information	Cartridge
Item Volume	10 Fluid Ounces
Viscosity	Medium
Full Cure Time	336 Hours
Water Resistance Level	Waterproof
Unit Count	1.0 Count
UPC	079340650497
Global Trade Identification Number	00079340650497, 10079340650494
Manufacturer	HENKEL CORPORATION
Part Number	2096329
Item Weight	14.9 ounces
Product Dimensions	2 x 11.13 x 2 inches
Item model number	2096329
Is Discontinued By Manufacturer	No
Size	Single
Style	Power Grab Express
Special Features	Repositionable,Waterproof
Included Components	Painting Supplies; Abrasives & Surface Preparation; adhesive-caulk
Batteries Included?	No
Batteries Required?	No

Power Grab Tub Surround Construction Adhesive - 10 fl oz Cartridge, Pack of 1

Details

Details

Description

Specifications

Reviews

Common Questions