REM Works LLC Windshield Mount for Dragy GPS Performance Meter ● This windshield mount for the Dragy GPS Performance Meter was designed to fit the Dragy perfectly so that it is held firmly in place when installed in the mount. ● Holes in both ends allow for the charging cable to be plugged in to the charging port without removing the Dragy from the mount if so desired. ● If needed, the charging cord can be plugged in while the unit is mounted on the windshield. ● Simply push the Dragy into the mount with the domed top (the domed top is where the status LED is located) facing the same direction as the suction cups. ● When mounted to the windshield, the domed top will then face the sky to allow the Dragy to obtain the best GPS signal possible. Notes: ● This is a 3D printed part and as such will have the typical surface imperfections that are characteristic of FDM 3D prints. ● The mount is printed using ABS plastic which is very tough and will tolerate the heat of being mounted to the windshield in the summer months.● Dragy and charging cord are not included.
A**R
Not bad but could be much better
Honestly if the tolerances were a little more snug it would make a much happier customer. The fit around the dragy is decent but the depth is quite a bit off causing the dragy to bounce forward and backwards on the windshield. We use these to get pretty precise measurements for acceleration, etc, so I can only assume it not being secure in the mount itself isn’t helping that. I could be completely wrong and it not effect it at all, but overall better fitment will go a long way in satisfaction
B**L
Fits the dragy perfect
It holds the dragy securely pointing in the correct direction (to the sky) and its easy to install and remove. I have a brand new car and didnt want to stick a metal plate to my dash. The dragy should come with this but I guess if you have an older car you wont care about the metal plate.
A**S
Great buy
Great buy
Trustpilot
1 month ago
1 week ago
