Bathroom Faucet Brushed Nickel Bathroom Sink Faucet with Pop-up Sink Drain Assembly & Deck Plate Single Hole Bathroom Faucet Single Handle

Easy to install faucet! Looks really nice and has really good water pressure! I highly recommend it!

Totally purchased 4 faucets to replace all my old ones. Already replaced 2 of them. BTW removing old Moen took 2-3 times more time than installing this new one. Old mounting hardware was so rusty and stubborn to remove. Amazing Force is all stainless steel so there will be no problem in the future. Installation is easy and you don't need any teflon tape or plumbers putty to get watertight connections. Just properly tight drain by hand. Rubber gloves will help you to get better grip. Drain come with thick soft rubber gasket which will properly seal everything. See my under sink picture. Just above stainless flange is white rubberlike really thick gasket. Manufacturer apparently changed design (based on reviews / feedback ?) There is no logo on the top (see my picture). Only H and C letters obviously. Also faucet diameter is 1 1/4 inch so will easily fit three hole sinks. Not 1 3/8 as some people claims. Checked with calipers. My sinks are 23 years old and accepted this faucet without any problems. No need to enlarge hole. Water supply lines are color coded for cold / hot water and a good quality braided stainless steel. I and my wife really like this design, it is very nice, has great water flow. Note: It is good after installing water lines remove (unscrew) aerator and then run water for a few seconds. First water will go really dirty and can clog aerator. After flushing lines install it back and you are done. The only thing I will improve is central mounting plate needed for three hole install. It's little too small to cover stains left by the previous faucet. Will prefer more square. But this is not an issue with a new install. UPDATE: Installed two more. One of those had reversed water supply lines. Red marked line need to be connected to cold water for proper work. Not a big issue but surprise after installation - cold water instead of hot. Go under cabinet and reverse lines. This is obvious that nobody is testing those faucets in the factory. I also remembered to record removing aerator and running first water after install. So you can clearly see not so clear water.

Good design and easy to install

I had been needing to replace the faucet in my half bath for a while now, thanks hard Florida swamp water!, but didn't want to spend a fortune. I like that this one is a bit higher and only has the one handle. What I love most about this one is that the water goes into the drain. The previous one was at more of an angle and would hit just past the drain. Since it is a pretty flat sink that made it splash up a lot. I did make the mistake of not measuring the center hole on the sink and this one was a bit too big. A little bit of sanding with a Dremel and it was good to go. I've had it on for only a few weeks, but it seems to be working great so far. Just bought a second one to replace the faucet in my main bathroom.

I bought 2 of these faucets and one faucet leaked and a plumber came out 4 times and couldn’t fix the leak until he found the drain assembly is defective! There’s no way to fix it and it’s causing the leak. I had to install a brand new drain assembly which is a different brand and the faucet isn’t leaking now. No thanks to the distributor Amazing Force for this fix!