LiZHi Silicone Case for Jabra Elite 7 Pro,Anti-Break Anti-Lost & Shockproof Easy Carrying Unique Dual Hole Portable Protective Case Cover with Carabiner for 2021 Newest Jabra Elite 7 Pro (Black)

I ordered this to protect my Jabra case. I almost sent it back because the fit wasn't exact, but I had already stuck it on the case and figured I'd give it a go.Pros:Protective yet not bulkyIt has a surprisingly sturdy, small carabiner clip, which I use to clip the case inside my bag (bag has an integrated key loop) so it doesn't float aroundAdhesive is holding upSo far it's durableInexpensive priceCons:The case doesn't fit exactly. You can see from the photo where it's not cut right and there is a gap. This is the best I could get it to cover, despite a lot of trying to position it to fit. It's mildly annoying to look at but probably doesn't affect functionality.Undecided:The adhesive is only on the top and bottom, so the sides aren't attached. This is both a pro (will be easier to remove) and con (debris can get in between the sides of the cover and the case). See photo.There is no little flap over the USB-C port; it's more convenient to not have to pry the cover off, worry about it detaching from the cover over time. The con is that dust, dirt--and let's face it, crumbs--get in.

Have had for almost a year now and holds up well. It stays on well and case is able to open and close smoothly. Not hard to reposition case. Had to warranty replace my jabra elite set and was no problem to remove and place on the other set, despite the adhesive on the case having been attached for several months. Great protection and extra traction when opening the lid makes one handed opening of case easier esp while driving.

This silicon case has double sided adhesive on the inside of the top and bottom of the case to keep it in place. The cutout for the charging cable is plenty large for all my charging cables and the indicator light is visible near the charging port. The silicon is about 1/16-inch thick all around the case and I believe it will offer protection when the case is dropped on a hard surface. The small S-Biner type clip the case comes with is doing a fine job holding my keys to my belt clip; I don't find any utility having it clipped to the case. The neoprene makes sliding the case in and out of my pants pocket a little harder than just the bare charging case, but it's not particularly bad.All told I'm happy with the purchase and expect it will protect the charging case for a couple of years.

Perfect fit and adhesive helps to keep it in place. It is a little too slippery for my taste but not too bad.

The red version can be seen and found easily and it gives basic protection. Would recommend.

Sturdy construction and attachment. It was a little difficult to get it lined up perfectly but once it’s on it doesn’t come off and it works well.

Good fit. Took a few tries to get right with the adhesive for the lid. Will protect from falls and scratches. Opening for the charger allows to see the charging light.

Installation might be off if you just plop the Jabra 7 case right in without figuring out the alignment first. In my case the first try there was a big seam on the clam opening. Easy to try again, just slowly peel the silicone cover from the Jabra case.

Moyen

It was easy to install and added an easy way to carry, and always have my ear buds with me. But the material attracts everything, dog hair, cat hair, dust. And I'm always needing to clean it.