USX MOUNTUniversal Speaker Stands, Height Adjustable Extend 30.0" to 39.1" for Satellite Speakers & Small Bookshelf Speakers up to 11 lbs Per Stand, 1 Pair Floor Stands for Sony Bose Polk JBL Yamaha

I wanted to write a review that is hopefully meaningful for those really looking for great speaker stands.....and like me, are struggling over what to do. I just purchased a Vizio M Series-Elevate, and knew I wanted my rear speakers on stands, to help amplify and surround my system. Also, I needed and wanted sturdiness as well as stands that looked good. First of all, being a professional musician for many years, and using microphone stands live for years....I didn't want heavy, round bases. Tri-pod stands are always the best, and these stands are tri-pod. They're sturdier, they fit better into weird and tight spots, (although, depending on your particular situation round or curved bases might work better. You just have to look carefully at where they'll be.) Next, was would they extend to the height I wanted. Absolutely. These stands have a speaker extension that allows you to get even higher that the 45 or so inches the stands allow for. However....if you have 8 pound speakers forget it, these stands are not for you, and the instructions tell you this up front.The speakers extensions were perfect for my Vizio speakers. In fact, using the screws that came with the speakers it fit perfectly, I have the perfect height. And let me tell you.....it changed how that entire system sounded!! Even TV commercials take on a whole new dimension. So stands for a surround sound system with rear speakers is a must! Also, these stands are perfect for box, or squared off speakers as there's a small platform at the bottom to hold, or rather set the speakers on depending on how big or small they are. The price was also well below what I had allotted for myself and stands. Very easy to put together and set up, the instructions made sense and I had it together in about 20 minutes. Then figuring out how to get my speakers on there was also easy. And these speakers are not squared or boxy, they're rounded off and kinda strange looking, but they fit perfectly and I couldn't be happier with my choice.So.....price, sturdy, ease of putting together, looks, and fitting numerous speaker sizes (except 8 pound speakers) these stands checked every box for me. I highly recommend them!!

The media could not be loaded. I have axiom audio QS4 surround speakers which weigh 9.4lb and was about to buy the official stand costing 1k shipped.I was browsing on Amazon and came across this as a bargain price of 40$ and purchased it.A lot of the reviews mention this is only meant for tiny speakers under 5 lb and it’s kind of true but, all you need to do is a teeny tiny tweak.The base is about 6 inches square and not too heavy. Straight out of the box, this will NOT support more than 5 lb speakers.I simply slotted an exercise weight plate of 10lb on the base. Standard plates with 1.5” hole will fit very well over the rod and sit on the base. You do need to wriggle it in if you use the screw at the base which holds the stand to the base and want the weight plate to stick to the stand bottom. (Please see pics).Read this carefully:1- I have dropped the stand to its lowest height and the speakers reach just the top of the sofa (see the pics).2- I have tried to push the stand and one has to INTENTIONALLY want to make it fall or it’s going to pop back up (watch video).3- I have slanted the stand up to 15 degrees and it pops back up.4- if you have small children, keeping speakers at this height can cause problems.The rods are thick enough to not bend with 9.4 lb weight and I think they are strong enough for even 20 lb but, you will need to add more weight plates to the base to adjust as per your speakers weight.ConsAs others have pointed out, unless you have super thin speaker cables, you must coil the cables around the stand and cannot route it through the hollow stand.

Am thankful for the reviews here on Amazon hence sharing this hoping it will help someone.Bought this stand for my Samsung HW-Q990D.[Pros]- Price is among the cheapest compared to similar stands on Amazon- Item is sturdy and well made (with minor caveat - see cons below).- Easy to ‘fish’ power cable through the opening- Manual provided, parts labeled- Assembling stand is relatively straightforward (took me 10-15 min)[Cons]- Part securing the speaker is slightly bent (see picture). Applies to both parts that came in the box- Has to slightly change how the bolt is securing the speakerOverall, this stand arguably works for this model. You get what you pay for I guess.

Soooo many speaker stands are WAY over-priced, so it's nice to see this set for a reasonable cost, easy to assemble, worked perfectly, adjustable/flexible, and to have both a channel to route cables and velcro to attach on the outside, these simply can't be beat for the price. Worth every penny, and they are decent looking as well.

I purchased Samsung HW-Q910D and was looking for stands for the rear speakers. Going through so many stands I was uncertain which ones fit. For anyone else searching these work 100%.Speaker Stand setup takes 10 min. Feed the wire down after attaching to the speaker. To mount the speakers on the stand for mine, no other bolts are needed then what comes in the stands box. It explains this in the directions, but for mine pictured, use key hole bolt N (the bolt is thinner on 2 sides to allow it to go to the top), and then use the butterfly nut O to secure.Exactly was I was looking for and adjust to the height I needed. I would recommend, only negative is it took longer than expected to arrive but worth the weight.