Nickson Industries (17705) 2-1/2" ID x 2-1/2" OD Exhaust Elbow

I used this elbow piece to dump my exhaust before the rear axle after I removed the factory muffler. Picture one shows original Nickson elbow pipe in place. In picture two you should be able to see that I trimmed some off at an angle and painted it with some high heat black. I did this to direct the outlet back some and painted it because you could see it through the wheel well a little. This elbow is a much cheaper alternative to an actual turn down pipe. Very happy with the purchase and with Nickson in general. (I used a Nickson 45 degree elbow for a turn down pipe on a 2004 F150. I elected to go with the 90 degree here because I am closer to the rear axle with this set up)

Works great

Did the job

Good

Nice & thick

This elbow is the worst piece off work . What a joke.