8" Pyramid Style Wooden Furniture Feet (Set 0f 4)

I am absolutely thrilled with this purchase! I own a $6,000 Arhaus sectional sofa (the emory) which basically sits on the floor with no clearance. It was feeling tired and dowdy, plus my elderly parents were having a hard time standing up from such a low position. I was really struggling with "giving away" such an expensive piece of furniture (used sofas don't sell for very much). So thought I would try this. I bought the 8" legs to raise it up. I put the 8" legs on one section and quickly realized it was too tall! (Like "Edith Anne" tall). I'm a handy gal so I cut the legs down to 4.5" (a little tricky cutting it since it is tapered on all 4 sides, but I used cardboard shims to straighten the tapers before cutting). I ordered mounting plates to go along with these legs, but I don't think I need them, the legs screwed in perfectly and feel very strong. They are high quality hardwood. I did have vertical corner dings on all my legs, but it's not noticeable at all once put in place. Now the couch feels fresh and new, and is much easier for everyone to get in-and-out of. Plus much easier to clean under it now!

The legs were beautiful!I had to order a replacement package because one leg had the screw in crooked .The second shipment had the screw off center quite a bit one one so, 3 good andone bad in each, I wound say to expect this and to not return the shipment until the replacement arrives so you can pick the good legs and send the others back.

We used these to replace the feet on a Restoration Hardware couch, which has an odd threaded stud, however was easy to install the studs from the existing legs into these new legs for a perfect fit.

Bought these legs for a thrift store desk that was missing the legs. It was a fast an easy way to make a $5 desk look fancy and expensive. They were a perfect fit, we had measured the holes at the bottom of the desk where they were predrilled and missing before ordering. These are on the longer side which is what we were going for. They simply screw in. We ordered the suggested hardware but it wasn't needed as there was hardware left ok the desk from the previous owner. You may need the extra stuff if you don't have it, otherwise there are screws attached and you should be able to use these straight out of the pack. Definitely a good purchase!

The storage bench in my guest bedroom now has the perfect height after I installed the 8" wooden legs, which took less than ten minutes to screw on. I am so pleased with this purchase.

I used these on my queen-size boxspring to turn it into a bed frame and they were perfect! They're extremely sturdy & made of hardwood, so no worries about them collapsing under the weight of my bed, even with me in it. I didn't like the look of 3 legs on each side of the bed, which I've seen on some DIY project websites, so I chose to go with these beefier legs and only use 4, one in each corner. I also added three 8" support legs (cut from a 1.5" x 1.5" post I picked up at Lowes). They look attractive and are well-proportioned for such a large project. Highly recommend if you're looking to get some extra space under a chair, sofa, or bed.

Purchased thinking my furniture used standard fasteners, given that it comes from a popular chain of American furniture stores. I was wrong. Had to order the adapter pieces and wait for their arrival to install. Not impressed with that combination, so I will be removing the larger studs from the original chair feet and install them in these feet. This should allow for zero gap between the feet and the chair, which it currently has due to the adapter pieces. Feet themselves are as described and perfect for my use, which was to elevate a chair for easier standing/sitting due to surgery. Works great, but I'll modify to eliminate the adapters purely for cosmetics.