GVNGrip Extension Fits Taurus PT111/ KelTec P11 9mm - 2 Pieces Black

Facts first, this is an aftermarket piece but there is nothing cheap about it. I put these on my Sig P365XL.I had to drill out the hole for the dowel on the plate which is on the bottom of the mag spring. That done, gently work into position and PUSH. It will "click" into position. Since it is an aftermarket piece. You will have to form it to the shape of your grip. You can get very close with a bench grinder as I did. Then with a rotary tool (dremel) and a sanding drum you can massage it into perfection. Now it looks like it grew there. Also, I have to mention that I put this on the P365XL so it is different than the P365. So if you don't know how to work with tools or think yourself out of a paper bag. Don't try this. You might hurt yourself and that would be your own fault.

These worked great. Didn't come with instructions but a quick Google search and was done in less than 5 minutes. Looked like it was made for the gun.

Ok so these grips are fantastic. I read all the reviews on these and some people said they don’t fit a Taurus g2c clip and some say it works , get it straight on the reviews . They fit perfect and yes there is a little gap between the handle and the clip but that’s alright . The clip still loads into the gun with no issues just a little advice don’t over think everything. Just buy them it’s not bad for the price and they are very comfortable too.

Poor

I bought these to extend the finger grip area on my Taurus Mellenial, G2, PT111 for my pinky finger, because reviews suggest that they "can fit".They mostly FiT but will require a 2 alterations to fit and install VERY WELL, still losing one round capacity.1) I filled in a little feed ramp on the top leading edge of the floor plate for the locking tab to ease installation; not a fit killer or necessity but it did make installation FEEL nearly as simple as the OEM floorplate.2) the hole for the locking tab (or button) is approximately 3/16" too far rearward; I filled away enough additional material to permit the floor plate lock tab/button to engage with the new extended grip floor plate located flush to the magazine's rear bottom edge of the magazine.NOTE$:When fully installed, there will be a ⅛" gap between the hand grip and the new extended grip which causes no negative issues for me. I am OK with losing 1 round capacity from the OEM Taurus 12 round magazine for the true grip extension comfort. It will not affect the capacity of 10 round magazines.

I ended up returning as it appeared the track the mag slides on didnt have enough space, and never "clicked" into position, while leaving a gap where the bottom of the grip and mag meet. With the concerns raised, I chose to return and avoid any possible negative outcomes. I did find another set that slide on MUCH more easily on an E-auction site for $6, click into place and leave the same gap as the original.

had to lookup installing properly, but fit an looks good

Was able to put it on my magazine for my Sig Sauer P365 XL pistol. Needed to drill the hole on the plate in order to fit the magazine. Than sliding the extended grip through the magazine bottom grove was challenging but possible. It is not a plus one, but worked because I have larger hands, it was the only extended grip I could find since it’s fairly a new pistol in the market. Hope this was help to anyone purchasing an extended grip for the Sig Sauer P365 XL