Fix It Wrap 2 INCH X 50 inch | Repair Wrap | Strong Fiber Weld Fix Reinforcement Repair -2 Pack

Use this to mend tines on plastic pitchforks. Little challenging to apply given how close the tines are but can be done. Still holding strong after 9 months.

Works well.

I’ve used this product to repair a shovel with a broken fiberglass handle and a long handled weed puller. The shovel held up to heavy use for over three years after application, and the product was well past the use by date. The weed puller has held up well so far. Before the repair, it had become useless in the hard clay ground we have in the So Cal desert. I absolutely recommend this product if you are a mender and not a spender but it’s not a miracle worker.

Works just as it says and describes

Item was OK. Instructions were pitiful and required guesswork to interpret.

I have a previous product on my tool and its there to help me grip it in wet conditions. It was beat up and I just wanted to put an over wrap on it. It was an 84inch wrap of a 3 inch roll. Applied almost the exact same way. Far more expensive but so far from what I see, a far better product. I saw this and immediately read 2pack of 2x50 rolls. That's what I read and that would have been a good deal. Turns out, nope, its a 2 pack, but each roll is about 25 inches. Secondly, the last 3 inches or so of the roll, wouldn't stick and were pretty much useless and had to be cut off because they wouldn't stick. Thirdly, the resin was real clumpy at the first of the roll. Wouldn't smoothe no matter how much I tried. I tried to show it in the picture. So yeah, not happy with it so far. When it dries, I'll try to paint it to match and hopefully that will be a little better looking and test its durability. I'm not holding high hopes at this point.

Product works as advertised. It was easy to apply and hardened rapidly. It contained the water leak for which it was intended. I am very happy with the results. My only criticism is that the ad shows two boxes of product and when received it was two products within the same box. Not having looked carefully before opening the box, I submitted a complaint which resulted in their sending a second set of wraps. I apologize for my haste in not reading the contents of the box.

I used these to fix my broken 24 ft push up fiberglass antenna mast, and a 22 ft push up fiberglass flag pole. The bottom section of the antenna fast was completely folded in half. The end of the flag pole section had two vertical cracks about an inch apart, and 4 inches long. The "repaired" antenna mast supports a 23 foot wire and is currently dealing with wind gusts of over 35 mph.