16 Pin OBD Female Replacement Wire Sockets Connector OBDII Car Auto Adapter J1962 OBD 2 Plug Shell Kit Fit for Specific Vehicle

Was making a bench harness for Tuning and it works great still functioning not broken. Would definitely recommend this for someone who’s trying to apply this to do an LS swap or a vehicle in the similar scenario. Overall great quality.

Worked out great

Not much to it. I think the dupont pins are cheap. When I try to clamp them for the wires they always deform easily. I ended up getting one from my local junkyard instead.

I ordered this to replace my original OBD-II connector that had some bent pins. After getting the leads attached to the wires, and plugged into the back of the female connector, I hooked up my OBD-II scanner. It was a really really tight fit Once they were connected, I had significant difficulty getting them disconnected again, and in the process of pulling the connectors apart, broke the new female connector head and yanked out the wires from my scanner, rendering that completely unusable. Tl;dr : plastic tolerances were way too tight causing the scanner to get stuck and both connectors broke trying to get them unstuck.

I received this item in record time…that was the first thing…the actual item is very good quality unlike the factory plug. Kudos to Amazon!

Worked for my engine swap. Quality is there. Would buy again.

Switched all terminals over.

Haven't actually used it yet, but it looks like it should work fine. Just want to make a test rig that supplies 12V to an OBD device.