TC-MotorRed Aluminum Engine Skid Plate For Honda XR50 CRF50 Pit Dirt Bike 50cc 70cc 90cc 110cc 125cc 140cc Lifan YX SSR Thumpstar Coolster Taotao Apollo Kayo

For 2020 crf50 I needed to clearance the bracket for the header. It’s cheap didn’t come with hardware you get what you pay for. Just wanted to be able to put up on a traditional stand for maintenance.

The metal seems good quality and the finish on it is really nice would definitely recommend

It doesn’t come with hardware, it came flat as a board, cheap anodizing, I didn’t even bother trying to find something long enough to fit so I just cut the rear 2 stilts (might be the wrong word) front end is pretty much made of butter so I just bent that to line up. I’d say it’s pretty much purely aesthetic I think a single tap of anything would probably bend it against the engine, as the title says you get what you pay for

This is not high quality by any means, but it was cheap and did the job for what I needed.It also required a bit of bending into place, came scratched, and did not include any hardware. If anyone decides to follow in my footsteps and get this I recommend setting some time aside for the install to fit correctly.Also it was a serious pain to even find out what bolts it needed, hope this helps someone else. This is on a stock 2003 Honda XR50I used these specific bolts.-M8 -1.25 x 40mm (metric 8.8) x 2-M6 - 1.0 x 20 mm (metric) x 2

It works for the price! The rear holes you have to buy longer bolts, the front two don't line up worth a crap, the color coating was chipped upon arrival and when you I ride my crf50 (2014) it makes a wierd ringing noise from the aluminum. But even with all that said I bought it so it would sit on a moto stand and it does just that! It really beats having it fall all over the place of having to place a wooden block under it. If it tears up I'd probably it another one for sure.

Good looking on the coolster 125 pitbike perfect fit

This plate was by far the best option for my 2020 Orion rxb 125x , fit very well with very minimal fabrication to get on

It was a little bit small for my 125cc I had to bend it to fit !!!!!