Creality Ender 6 Full Hotend, 3D Printer Replacement Parts Assembled Full Hotend Kit with Teflon Tube, Fan, Blower Hot End and Metal Shell for Ender 6

Original one made noise and this was exact replacement.... Bought a second one to have spare on hand now....

only slight draw back is the fan duct wasnt as directive as the one from my original part (2 screws and it swapped out) and the plastic tubing around the wires seems to be larger than the factory one requiring a little change on wire management. aside from this bolted in perfect and all plugs went in fine.

The thermistor and heating element were included.

This has already failed. Barely lasted 2 weeks. The fan quit and hotbed doesn’t keep consistent heat. Definitely a faulty unit. I hope the seller will replace. Seller please contact me asap.

Doesn’t come with a thermistor. Did not fix our heat error because of no thermistor.

official creality product, does not come with new sensor so will need to use exsisting one or buy one. however prebuilt and ready to go. great product

Ricambio perfetto montato in meno di 3 minuti tutto perfetto e funzionante

Leider nicht komplett wie beschrieben.Kabel befinden sich in einem ganz billigen , dünnen Kabelkanal

After fitting this my ender6 is now printing better than with what came with the unit.You do have to route the stop sensor wire around the outside though. It was inside the original not the end of the world at all. I guess you could poke it through the plastic tube with a bit of effort.All in all very pleased, and it comes with some extra nozzles.