2Pack LED Ceiling Fan Light Retrofit Kit, 6inch 24W 2200Lm, 3CCT Dimmable

Magnets hold module very well, installation very simple, and light is very bright. Installed in 4 ceiling fans that used incandescent bulbs. Prior to installing these lights, lights were extremely dim, even when using led screw in bulbs. Now I do not need additional lighting to see paperwork, etc. I highly recommend these replacement lights. Update on original review: I still love the lights but one went out after only 8 months. This light is in the office and not on most of the time. The seller should send a replacement but I can't find a way to contact them. Additional update 08/29/2024: Seller contracted me and is sending a replacement. Great customer service and great product.

I installed this in a ceiling fan that had a halogen 100W light. The brightness is similar. I removed the old lamp hardware and fitted this LED unit with a few pieces of hardware into the housing. It took about 15 minutes to modify, not counting driving to the hardware store. It directly wires to a 120V source. No adapter or anything else required. The modification required for your fixture will vary, but I am running it and it looks good. There is a three position switch that selects the color temperature. I chose the middle setting. It works ok with the fan's old dimming control except at very low levels where it sometimes flickers. 3/4 of the dimming range it works perfect. The last time I replaced the Halogen light bulb it was $10. This cost about $18 even with the added hardware, it uses 1/4 of the electricity and runs WAY COOLER.

Excellent and an upgrade from earlier models, fits great and works great, Thank You

Thees lights are bright and easy to install if you’re competent and comfortable with simple wiring. I retrofitted two halogen light fixtures with domed lenses whose bulbs were rated at 150 watts when they were new five years ago. I gutted the old innards, and these LED pucks just popped in and are well-held in place by their magnets. These LED lights are brighter than the old halogen bulbs, and the color balance is perfect for our closet. Dimming is good too. Overall, I am impressed with the quality of this product!

GREAT light, and adjustable color temperature. I had a little more trouble than I had planned with the fit, as there needed to be a longer stem to attach the light to our ceiling fan. I found what I needed at Lowe's to take care of that issue. I bought the two pack of the lights, so now I'll know how to handle the installation on the second fan these will go on. (I bought a dimmer from a local hardware store, as these are dimmable lights, and I thought the light might overpower the room. They don't with the glass cover that was already on the fan light. The light unit provides a good, overall coverage of light for the room.

Have had similar lighting challenges as others with fans not producing enough light and LED bulbs not lasting. I hope these hold up well for us as the quality and amount of light is very nice. It was a bit difficult to make the bulbs work in the fan enclosure with the magnets and the wiring with the space between the bulb and the magnets. I don’t blame the bulbs though as they cannot handle every manufacturer specification. Happy with this purchase so far.

They're very bright and have good color on the middle setting. I installed them in ceiling fan fixtures that previously had 2 incandescent bulb sockets and wiring passing through a threaded tube in the center. Installation would have been even easier if the clear plastic cover had a small cut-out in it above where the mains wires solder to the PCB. That way the light could be secured to the threaded tube with a nut, wires pass out through the cut-out and into the end of the tube. As is, the wires pop through the side of the cover's tube - the securing nut would have to crush the wires against the cover. It's easy enough to take the cover off and drill a couple holes, but it slows down installation.

It was good when it was working. But as of a few days ago, this LED and the other pair just died out. I bought another highly rated one listed here to replace it. When it was working, it was quite bright and fairly straightforward to install. I had it in a ceiling fan. When one was starting to go out, it was flickering. The other one straight up stopped working. Checking out the flickering one, I noticed it was really dim because it over half of the LEDs was not lighting up. This one failed probably due to the connection in the selector switch. The one that outright died looks like the LED driver died. Value for money? Yeah, It was worth the less than $30 for both of them, even though it only lasted exactly two years. Fortunately I installed it, rather than an electrician

Fits perfectly. Five stars.

Es una excelente opción para poner en abanicos con luz fija. Te permite escoger tres temperaturas de luz!

El tamaño perfecto y facial instalación