Cabin Air Filter Retrofit Kit Replacement for 07-14 GM Chevy Silverado Sierra Tahoe Yukon Avalanche Suburban Cadillac Escalade

Just installed this in my 2005 Suburban. Fit fine. Not sure why it is listed for just 2007++. Cutting the plastic out is a challenge. Utility knife was too dangerous, so used Dremel with several bits. Used utility knife and a round Dremel sanding roll to get it right. Filter did not come with any instructions as to how to install. The pull tabs go on the bottom . The filter has cuts along with side. This is aimed toward the blower motor. These allows the filter to be bent so it does not hit the floor. Pure brilliance. Seems to be good quality and the door was very rugged and comes with foam that really seals the opening and a screw to lock it in place. Great value for the money.

The kit itself is perfect. The work you have to put in to cut the hole is a little tedious and a pain. Go SLOW and take your time and you will be fine but it is frustrating. Worth the effort overall though!

Fit perfect, you’ll have to cut out the factory bottom if you never replaced your filter in a 07 Tahoe but the filter and bracket go right in

Good product fit like it should

would of worked except my 2013 gmc is a sealed unit and has no cabin filter

This is a nice addition to my 08 2500HD since it didn’t come with a cabin filter. The filter and filter door are surprisingly of really good quality. The airflow after install is quite good.Install: Remove plastic cover to expose filter/fan area on passenger side. (3 screws). Use a utility knife to cut in groove to remove plastic cover where filter will go. Make repeated passes with a sharp new blade until it cuts through. (Take your time and make sure you don’t cut out of groove. Could be a big problem). Change blades when dull. My vehicle has a clear and evident spot where filter is to go. It even has area to accept screw. Once opening is removed, slide filter up in slot. You will have to curve filter slightly to feed it in. (Perfect fit in my vehicle). Hope this helps some out there. (08-14 are usually about the same)

The piece that is supposed to hold the new filter in after the hole is cut out, was missing. Someone may have returned it like that, but the screw was in there for the cover plate, just no cover.

This was not expected when I went to change my filter. GM decided not to install cabin air filters from 2007-2014. Uh, come again? There are YouTube videos on how to install this retrofit. You basically need a sharp utility knife, small hacksaw, or a oscillating multi tool. It took me about an hour to do it all. I also took a moist toothbrush to the AC coil to get the years of dirt and grime off of it where a filter should have been keeping it clean. Just the typical tale of saving $0.80 per vehicle.This product worked great. Not sure how good the filter is, but again it's better than NO filter that was there. The cover fir perfectly and came with screws to attach it to the mounting stud that was there, proving that GM was going to do it, but cheaped out. This isn't a negative review for this kit, it's one for corporate oversight or greed.Sorry.Good kit. Would buy again.