Perforated metal sheets 0.32" 1/3" 8mm

Sheet arrived as described. Piece was cut true and straight. Polished and had plastic wrapped around entire piece. Used it to make an hvac return air grill. Works fine for this application.

Nice. Exactly as I expected, which is rare these days, lol.

As described. Perforated stainless steel sheet. Used it to create a cage around a bathtub heating element to keep the tub warm while avoiding burns.

Or in my case, customize the silencer length on my 2 stroke engine exhaust. Thick, sturdy, stainless steel. I used it for this but can be used to make many things requiring perforated holes or plate

Good product.

I ordered one 7.8 Inch X3.9 Inch-Metal Mesh Sheet to evaluate. It was beautiful, and perfect for my use. I am making a small component rack that requires 4 of these. Based on the quality of the first one I ordered three more to complete my project. Sadly, none of the three in the next order match the first one I ordered. Not only is the finish different, but the spacing of the holes doesn’t line up. At first I thought I would be able to manually line them up, and trim the edges to match, but it turns out the spacing of the holes is different. I thought this was probably my fault, as I should have ordered all four at the same time. But even the three in the second order don’t line up with each other. Not only are the holes “out of sync” but the sheets themselves are different sizes. My guess is, the supplier is cutting these out of a larger sheet of material, and not using any kind of alignment template. So some pieces are cut out from the horizontal direction, and others vertical. (That’s just a guess.) If your use doesn’t require any alignment then I would recommend this material. I’ll have to return mine and try something else. Perhaps I should order one large sheet and cut out of that to get a good alignment.

Way more solid than I expected! I have a grate outside our garage that use to have a chicken wire filter under the grate to keep debris out of the drain. Naturally this rotted out rather quickly causing stones and leaves to get into the drain line requiring me to hydro-jet it. This sucker fit EXACTLY right giving me a 1/4 in clearance around the drain so it slides right in. Had a TORRENTIAL rain today and zero clogs. Wish I had found this about 5 years ago. Hoping they make a few round ones that fit pipe ends as the plastic ones for 4in pipe seem to get damaged way to often.

Used this to cut a custom-sized bottom plate to replace the original cast iron part (that repeatedly failed) in a Primo charcoal grill. Has endured multiple 800+ degree pizza cooks without warping. Too thick for sheet metal shears but easily cut with an angle grinder with a cutting wheel. Solid.