🚀 Cool Down, Power Up! Your ultimate cooling solution awaits!
The Diann 2pcs 5015 3D Printer Cooling Fan is a high-performance, brushless blower designed for efficient cooling in various applications. Measuring 50x50x15mm, it operates at a speed of 5100 RPM, delivering a total airflow of 6.5 CFM while maintaining a low noise level of 36.5 dBA. With dual ball bearings for enhanced stability and durability, this fan is easy to install and suitable for continuous operation across a range of devices.
J**N
Upgraded got end cover
Used these fans for my hot end duct set up. These fit perfect in my print and are extremely quite. A lot more so than the stock blower fan my neo came with
M**D
Solid Upgrade
Solid upgrade over the stocker fan on my Ender 3 NEO.
R**N
Wires reversed out of the box for +/-
Beware, the two I got had the +/- wires reversed so I had to clip the off the plug and solder the wires correctly. This wasn’t a huge problem for my situation as I was splicing into a place where I couldn’t use the plug anyhow but I discovered this when attempting to test the fan prior to splicing into place.Once that issue was fixed the fans work as expected.
B**N
Simple fans
Great upgrade for my 3d printer. Working perfectly.
L**S
Meh
I got these because out of all of these model of fans I could find, these seemed to be the best reviewed for noise. But one has a bearing out damn near immediately, maybe 20 hours of use and it will occassionally just make a racket until I go thump on the fan a little bit. Annoying.
P**H
cheap and reliable
3 weeks in on my 3d printer and still going strong with no premature bearing wear
K**E
One bad motor and one barely working
Bad motor son first fan I tried and second fan clicks while it’s running. It works but not sure it’ll work for very long.
B**W
Moves Air
These fans move a ton of air, but is very noisy at the same time. About 80db with the fan shroud.
Trustpilot
2 months ago
1 week ago
