FEL-PRO MS 92211 Engine Intake Manifold Gasket Set for Chevrolet Silverado 1500

The gasket was a perfect fit and went together as it should

Buena calidad thanks

FelPro gaskets have always fit well and worked well for me over the years on many car projects. I use FelPro gaskets whenever possible

Good product, just wish I would have known about the new updated and improved metal style gasket felpro makes, but whatever, these should last a while

Exactly what my vehicle needed, cheaper than local parts store. Truck runs much better now!

I needed these to perform the knock sensor job on my 5.3 silverado. I opted to purchase these FelPro gaskets because the AC Delco ones are 3x the price. The gaskets arrived undamaged and were shipped in a thin cardboard box inside of the sturdy amazon shipping box. They were an exact replica of the original gaskets with the only notable difference being the silicone was a different color (blue instead of orange). The molded clips made it an ease to reinstall the manifold. You do not want to do this job and end up with a vacuum leak at the end. Lookup the torque specs and torque sequence for your vehicle. The manifold did not have any leaks upon start up so im assured this product performed its job well.Some things to note if you are performing the knock sensor job on a GM:Make sure you have an open weekend to perform this job, It will take upwards of 6-8 hours.As noted below, since the manifold will be off, now will be an excellent time to replace optional parts. You might also want to do additional maintenance such as cleaning the IAC, MAF and throttle body.Parts you will need:2 Knock sensors (usually only the rear gets damaged but since this is a large job you might as well swap them both)1 Knock sensor harness (The old one will be useless. The boot wont seal tight and the connectors will be brittle and likely break)1 Intake manifold gasket (This is a given. You do not want to do this and have a vacuum leak after putting it all back together)1 Throttle body to intake manifold gasket (You will problably unmount the throttle body for easier removal and cleaning)1 RTV tube (High temp is preferred. This is used to create a dam and keep water from entering the knock sensor and corroding it)Miscellaneous Optional:1 Bottle of Throttle Body Cleaner (While the whole manifold is off you may take this time to clean the throttle body thoroughly.1 bottle of MAF cleaner (To clean the Mass Air Flow sensor and Idle Air Control Valve)Some Shop Towels: (You will be doing alot of cleaning of parts caked with grease/dirt/grime)Shop Vac:(No matter how careful you are chances are leaves or debris will fall into the cavities of the valves/knock sensor while removing the manifold. A shop vac makes quick haste of cleaning all this debris)Other parts to consider replacing while you have the manifold off:Valve cover gaskets w/grommets(This is a perfect time to replace the valve cover gaskets if you notice any small oil leaks)Heater Hose Quick Connectors:(These things are also notorious for breaking in alot of GM trucks near the firewall. If you have never replaced them, now would be a good time to replace them since you will have easy access to them)Note: I did not include any part #'s as they will vary per vehicle application.

Great gaskets

Installed on my 2002 silverado with the LM7 5.3L, stock intake “truck” manifold. Gaskets fit perfectly and sealed perfectly. It’s very important to know and understand the instal process on these LS motor intake manifolds. the bolt torque specs are very light. felpro intake manifold gaskets have about 8k miles on them and are still looking brand new/working as should. highly recommend

works great

Perfect fit on my 2003 silverado 5.3. Very easy to install i did these when I replaced my knock sensors. Glad I ordered them because the stock ones were completely flat

Just what the doctor ordered

felpro make good gaskets.

I've installed it and so far so good.What can you say,either it works or not.