1 X 9V Battery Connector (10 Pack)

I was hoping the wires could be disconnected from the terminal, so I could simply attach it to my existing wires, but no such luck. I couldn't get to the source of my existing wires either, so I had to trim all wires and solder them together. It worked ok, but wasn't as easy as I would have liked. Terminals are fine and work well.

I found my multimeter inoperable at the time I needed it most. The battery had almost disintegrated and the acid had destroyed the wires and the contact ends which snap on. I didn't realize the wires were eaten away all the way to the circuit board, so trying to replace the contact end with a replacement with short leads did not work well. I found this on Amazon. Where else? It was shipped quickly and the leads were long enough to thread through the case and to the circuit board. Saved the Multimeter. Contact ends are just fine and hold on to the new battery as they should. Great find.

Stated shipment time was incredibly long. Had to call to check on order status twice. Turns out shipment was lost. Finally received. Worked well but seemed to be a little weaker power.

The connector pictured is heavy duty with a plastic cap, which is what I wanted. What I received WEEKS after ordering, was the standard, flimsy cheap type of connector. Don't waste your money or time with this if you want a quality connector.

FALSE ADVERTISING : This is the basic cheap, flimsy, 9v clip. The picture shows the heavier duty style. Heavy plastic....Bad Form...... I called amazon and reported the issue weeks ago. I can see that the picture hasn't changed. Amazon is not doing it's due diligence to protect it's customers even when notified of it's third party vendor's infractions . Very disappointed

receive a soft shell type instead of the hard shell type in the picture. these soft shell type is only sell for $1 for 4. Very unlike!

The connectors were flattened when I received them - not sure if they started out that way or it occured during shipping. But, with just a little bending back out with a small screwdriver, it attached fine to a 9V battery. I replaced a defective connector in a carbon monoxide detector with this one, and it has been working fine ever since, so it got the job done.

I purchased this connector based upon the picture above which shows the Hard Shell Heavy Duty 9 volt connector. What I received instead was the cheaper soft shell 9 volt connector.