16 Pcs BNC Male Plug Crimp Connector for 50 Ohm RG58 LMR195 RG142 RG223 Coaxial Cable

When I purchased these I thought they would be like any other BNC connectors I bought in the past for use with RG58A/U, but this wasn't mentioned in the specs. These will only work with RG58/U coax with a solid conductor. Stranded conductor wire as used in RG58A/U is aprox. .005" larger and will not fit into the center conductor pin. So...I can only use these with RG58/U coax.

These do not fit rg58. The center hole on the pin is far too small.

Nice quality product. The only thing missing is measurements for proper stripping of the coax shield and center conductor.

The hole on the pin was too small to fit the conductor on RG223 cable. There is also no solder hole in the side of the pin to solder the pin to the conductor.

The center conductor does not fit the center conductor of the RG-58 coax. You must get a .040 inch drill bit and drill out the pin in order to crimp it to the coax.

Did not fit cable

Same as a few other responses. The Center hole of the center pin is too small for the 0.8mm RG58 center conductor. Have to drill them out or use a different brand. The connector and outside crimp looks pretty good though.

The ferule (crimped to affix shield to connector) is too thin for bog-standard 0.213" die, but two sacrificial wraps of a strip of aluminum cut from a beverage can make it work. Even heavy-duty aluminum foil is too thin for this workaround.