Garage Door Sensor for Chamberlain Liftmaster Sensor Replacement Safety Sensor Beam Eyes for 41A5034 Liftmaster Sears Chamberlain Craftsman Opener Parts(1 Door)

Easy to install and all the hardware was included. They have been working great for months. These are a good buy.

It worked

Other than one of the lead wires arriving broken and a little short (see picture), these were easy to install and and working great so far. I opted to not use the little snaps to connect the wires from the sensors to the existing wiring. Instead I used the wire nuts that were on the old sensors. One of the old sensors was apparently going bad so I swapped both of the old ones out with the new pair. Garage door is going down just fine now. Installation for both, even after stripping the short wire back a bit, took less than 10 minutes.

Waste of your money.I bought this product because a similar sensor item failed. This product is exactly alike. One of the sensors was dead on arrival.After two failures, I physically went to a B&M and purchased a genuine Chamberlain sensor.

pretty easy to installed. I used it to replace my old one. The wire connectors that came with it were handy and useful.

replaced my old 10+ old sensors. working great and easy to install.

Came with the connectors, wired up just fine, worked.

This was not compatible with my craftsman garage door opener. The opener was made in in 2008, so not super old but not new either.