Chupacabra Offroad UTV Universal Rear View/Side View Mirror 1.75 clamp

I ordered this mirror to replace the one I had on my sxs. I found after installing a soft top on my 17 pioneer I could not see the mirror on the left side while sitting in the drivers position. I needed a mirror to be legal in ND so I ordered this mirror to replace the original and found it worked well. It is larger and easy to see the left side of the vehicle plus upcoming traffic. I did have to extend the mirror out a bit further using an additional mount. But it worked as stated and I am happy with the results.

I like the mirror and bracket itself, it fits well on my new Polaris 570 full-size with the round tubing. The visibility is excellent. I too had trouble with installation, even after watching the youtube video, I think the bold is just a bit too short. I ended up buying a different bolt and nut to make it work. Wish it had fit perfectly from the start. Other than that, I like the mirror very much.

Watch the video listed in the description to see how to assemble. Without knowing it can be frustrating. I installed this on a Kawasaki Mule. As others have stated, the bolt to attach the clamp to the pipe does not seem to be long enough. I cut the supplied rubber gasket to a shorter length and the bolt will work and clamp very securely. Stays in position well on the rocky rough roads where I hunt.

Not sure why there are reviews complaining about there being no intructions. If ya can't figure this out you should be going to the dealer for accessories. Went together in a snap and just use your head tightening the clamps as it is plastic after all. Do not worry about the lack of instructions. Mirror is good sized and rugged enough. If I smack a branch into it it it will probably break but I don't fault the product. I would just buy another and motor on.

Cheap-low quality... You get what you pay for...no instructions... Not that it wasn't obvious (for the most part) how it goes together. I had to modify it just to get it to tighten up. I still don't think it will last one ride...i plan on using some "lock tite" to hopefully keep it from moving around.Wouldn't order this again...too much flimsy plastic parts.UPDATE... I used some lock-tite to help it from moving around. And the fist ride was a success. I have to say the mirror is large and has great coverage-you can see well behind you. So i raised my score from one star too three stars.

If the Chupacabra mirror has a fault, it is that the mirror head is too large when used as a center-position rear view mirror. The design is highly-flexible, allowing for a wide variety of positioning options. For now, until I get a roof, I've installed the mirror so it extends above the front roll cage cross bar looking down behind our Pioneer where it is very useful helping avoid backing into boulders or stumps or over precipices.

This is a great product, I like the mount design and after a better bolt and 2 layers of duct tape inside the bar mount the mount sits tight and does not move. The mirror is HUGE, and has good viability however because of its overall size and the way it mounts to the post the wind coming into the unit, I have a half wind shield, pushes the mirror up or down and I have to constantly adjust the mirror. A bit distracting if riding on streets.

Looks great. I had to add a piece of rubber under the clamp to make it snug on my Yamaha viking. I have only had one ride with it on so we will see how it lasts.