Hot RacingAON38A01 Aluminum Center Differential Mount Arrma Kraton Outcast

I suggest if you buy this that you use some fine grit sand paper to remove a hair of material from where the bearing seats. I tapped mine in with a wood dowel. It wasn't a snug as the HR adjustable motor brace, but was still a tight fit that will probably be tough to remove later when the bearings need replaced or the diff needs work.

Be prepared to get out your 4 mm bottoming tap to clean out the threads for fasteners, threads are not complete.

Best for 6s running . Much needed a lot better then stock plastic . For older 6s models

the screws it came with seemed a bit long or maybe its just i installed wrong but id reuse the old screws with this.

Pleased with product. Fit was perfect.

Significantly stronger than stock plastic. Very solid.

Way better than plastic!

Another good job by Hot Racing!!