Trotec TroLase | 12"x12"x1/16, 8 Pcs | Blue/White | 2 Ply | Modified Acrylic | Laser Engraving Double Color Plastic Sheet | Engraving Blanks for Laser, Saw, Guillotine | Made in USA

It only took a few tries to dial in the settings I needed to etch my first item on a XTool P2 CO2 laser. By inserting the bottom edge into a vise and applying some heat with a heat gun I was able to bend the bottom to make a free-standing sign for the song catalog at a local karaoke show. The picture shows my sign. Note that I should be able to get better bends with some additional practice.I had to turn the air assist down to its lowest setting to reduce the amount of dust created by the etching process, and then rubbed the finished piece with melamine foam (a.k.a. Mr. Clean Magic Erasers) to clean out the etched areas.My order arrived within the promised delivery window and I will definitely be using them again.

Works well with the Laser engraver. Great for making plaques

So this material laser engraves and cuts easily. Any place you laser it though is very sticky when done, tried a few things to clean it with little success, then asked Trotec and they said to use magic erasers (melamine sponge) and it works, no need for soap or water or anything, just scrub with the white sponges and the sticky goes away.

Etched nicely.Packaged well.

Trotec TroLase | Laser Engraving Triple Color Plastic Sheet | Red/White/Red | 3 PlyI plan to use the sheeting for making holiday signs and ornaments on my router CnC machine. The two outside layers (red) will give way to the white interior layer for a two color finish. The layers look durable, even the outside layers are very thin (0.003”).There was a slight problem with 2 sheets being undersized, but I texted the company through Amazon and they shipped out replacement pieces right away. Excellent customer service response.

As advertised, quality product well packaged, delivered on time.

Looked nice and good concept but did not perform under the laser as expected.

This is a great product for use with my laser. It cuts and engraved so nicely. The only downside is the smell......its much stronger than a typical acrylic smell. Outsidr of that its a terrific product. Perfect for making signs, keychains and even logo magnets.

Very good quality product and fast delivery. Recommended.

We use and x tools D1Pro. When engraved, the white engraving shows up really well. Doesn't have burn marks when engraved. Some of the square we received were scratched and chipped. I didn't have time to deal with sending them back.