🔥 Light Up Your Kitchen with Confidence!
The Flat Igniters 5303935066 is a high-quality gas range oven igniter replacement designed for various brands including Electrolux, Frigidaire, and Kenmore. With a total length of 11.5 inches and an amp range of 3.2 to 3.5, this igniter ensures reliable ignition for your oven. Easy to install with just basic tools, it offers a cost-effective solution to common oven issues, backed by a 1-month warranty for peace of mind.
| Manufacturer | yl super products |
| Part Number | 5303935066 |
| Item Weight | 4.2 ounces |
| Package Dimensions | 5.63 x 3.27 x 2.95 inches |
| Item model number | 5303935066 |
| Item Package Quantity | 1 |
| Batteries Included? | No |
| Batteries Required? | No |
A**R
Perfect
Work great and got it right away
M**Y
Works great!
Fixed my gas oven easily with this piece. Great product.
J**R
accurate item
I can't say the longevity of the item is able to be determined.
M**R
Waste of Time and Money
This was installed by an appliance repairman($$). It fired up the oven 3 times and died.
J**8
Junk
The plug didn’t fit my application so I had to directly wire it to my oven. Then it only lasted 3 months and had to be replaced again. I went with a factory replacement part this time.Update: I upgraded my review as the company reached out and offered a refund due to the quick failure of their product. I appreciate a company standing behind its products.
L**S
Works with Frigidaire range oven
I installed this in a Frigidaire stove/oven. Simple installation. I did have to cut the leads and use the ceramic wire nuts. The nuts were not a good fit, but good enough until I buy new ceramic wire nuts. The element glowed orange and the oven ignited in about 45-60 seconds. It seems forever when you're watching, but I'm sure 45-60 seconds is good enough.Installation: [Caution] turn off gas and electricity if you are not an experienced technician. And even if you are.1. take out racks.2. remove oven floor (two screws in the back). lift the back, pull towards the back, lift the front.3. optional: remove oven door (remove 2 bottom screws, position door in ajar position, lift door up and out). You might hear the snap of the latches.4. remove flame spreader plate. One nut at the top.5. remove 2 nuts holding igniter assembly to burner.6. note position of wires relative to igniter.7. cut igniter wires (about 6 inches out). discard old igniter unit.8. using wire stripper, strip 1/4" from each lead from the oven9. using wire stripper, strip 1/4" from each lead of new igniter.10. connect the leads in the same orientation as before using ceramic wire nuts (recommend buying new ones).11. attach new igniter unit to burner with the 2 mounting screws.12. install flame spreader (one nut).13. install oven floor (two nuts in the back).14. optional (reinstall door, screw in 2 bottom screws): this is the most time consuming step because the door latch will try to snap back.15. That's it, you're done!16. Turn on gas and electricity. Test the oven by turning to 250 F. Wait for it to turn on. open door. wait for it to turn off. This is a test of the igniter and thermostat functions.
B**X
easy install
Very easy to install as long as you have all the right tools. I installed it in less than 30 mins but it would have taken me less time if I owned a wire stripper tool.
N**Y
Works
Fixed the problem,
Trustpilot
1 month ago
1 week ago