MobilefoxUnder-desk docking station wall holder suitable for CalDigit TS4 Thunderbolt Dock

the choices for this are limited and 3D printed for the job and I certainly gives you back some desk space and remove all those unsightly cables, however, do not rely on the adhesive pads to hold it, as the heat soon made the TS4 drop from the desk onto the floor, thankfully no damage was done and I should have known better than to trust glue alone! I further screwed the brackets in, but this is also a little tricky as you have to make sure that the brackets are straight, if not, it is a nightmare to put the S4 into the bracket, so you need to spend some time making sure it's level. In the ideal world, you would fix the brackets with the sticky pads, then mark and drill the brackets into the desk...... however, we knew what happened to my stickiness so I had to get under the desk and I did a bit of a bodge job, which meant I was difficult to get a solid fix and the TS4 moved every time you tried to fix a cable in, which usually disconnected the monitor, etc because of the cabling. Had to take it all down and re-do it ensuring that it was level, which took some time, but ultimately I am a lot happier with the bracket, I prefer it under the desk and now I've upgraded to a standing table, its a lot easier to access. Would recommend it, but take your time to make sure it's fitted properly would be my advice, and measure once and then measure again, it'll save a lot of pain in the future. As for the build quality, it's two 3d printed brackets, they appear stable and I'm not removing the dock a lot, it seems to hold everything in place and the heat from the dock hasn't melted it yet, and it does get hot, I tend to leave it on 24/7, so that's good for me. The price is probably appropriate for what you are getting, and it's the only one on the market, so supply demand, If I needed another one, I'd order one, so its a recommendation from me, but not a five-star, fitting is just a pain and would have been good to be advised not to rely on the adhesive labels, get that fella screwed in and put 45 minutes aside to do it.

Support bien pensé et bien adapté. Juste pour faciliter la fixation la fourniture d'un petit patron papier serrait le top

Die Halterung ist ziemlich miskonzipiert. Das CallDigit Gerät geht kaum richtig rein und bleibt auch nicht drinnen, sondern fällt gerne mal raus, wenn man es nicht vollkommen unangetastet lässt. Klare Nichtkaufempfehlung.

Alles hat super funktioniert. Von der Anleitung, zur Montage, bis zur Verarbeitung passt es perfekt.

Sehr unfreundlicher, nicht entgegenkommender Service! Sehr späte Antwortzeit (teilweise nach mehreren Tagen). Produkt ist gut. Generell bin ich aber aufgrund des schlechten Service unzufrieden.