Canpump CH 2830 G: 2800 psi @ 3 US gpm, 3/4-in Shaft Pressure Washer Pump

Replaced pump on Troy Bilt pressure washerThis pump is awesome, well made and very powerful. The pressure regulator is a bonus and functions very well.Installation was plug and play. Had a few questions so I reached out to Canpump.Their support was excellent. They are located in Ontario and are very knowledgeable ! In regards to pump oil issues.The pump comes with the required amount of oil already in the pump.. To check oil. This is done by removing top temporary plug, take the dipstick off the breather tube, insert dipstick into pump. Then once you have verified that the oil is full, install the breather tube into threaded opening reinstall dipstick into breather tube and hand tighten the breather tube. The breather tube must be removed each time to verify the oil level.

Originally I had a Generac Pressure Washer 2400 PSI and I had an issue with the pump. It started leaking and I found a bolt had broken off holding the valve assembly to the pump and causing a substantial hi pressure leak. I found out the pump (189943GS) had been discontinued as well as all the service parts and this pump was listed as a replacement for the 189943GS unit my pressure washer originally came with. I could have corrected the broken bolt issue bu it i need a gasket or seal also I figured it may be more trouble to try to locate a compatible seal so I decided to replace the pump and look at the pump for possible repair later. I purchased the pump and found it to be slightly larger and with a different in let and outlet configuration which facilitated a slight modification to the frame to add easier access to the attach the hi pressure hose. The water inlet was no problem and required no modifications for access to attach the hose. The pump bolted up perfectly to the Honda GC 160 engine that the pressure washer came with. The pump body for this unit seems to be about 2 times the length of the original although the over all length of the pump was not that much more than the original pump and created no issues. The new pump is a beast. the output is better than the original and the GC160 will carry the pump but it the GC160 seams to work a little bit harder. This was a great replacement pump with no problems so far. At this point I would recommend it if it fits your application but remember in my circumstance it only required a slight modification to the frame to get better access to attach the hi pressure hose. I expect a long service life from this pump due to the hi quality it appears to have when I initially unboxed it ..... time will tell.

Bought it to replace a defective pump on a champion 76525 pressure washer and it works great, it's easy to install although the instructions for the oiling are a bit confusing. Overall good product.

Arrived on time and in well packed box. Quality seems good. Fit well on my Generac pressure washer. Installed very simply in a matter of minutes. Came with a nifty 'dip-stick' to check the pump oil. Getting the oil level 'just-right' took a little bit of patience but I got it. Then I was back in business with my Generac pressure washer. We'll see if it holds out - this time around (my 3rd pump) I'm going to be a lot more attentive to winterizing (pump fail #1) and changing the pump oil (pump fail #2).

Hooked to a 5hp Yamaha. Compared to the last pump head this pump head is smaller and has less volume of water. If you are booking this up to a 5 hp I would go up a few psi and gpm than listed on this pump head.