HICTOP Ender 3 Heated Bed with Cable 24V 220W Compatible with Creality Ender 3, Ender 3 Neo, Ender 3 pro, Ender 3 V2, Endder 3 V2 Neo, Voxelab Aquila X2 3D Printers

It worked as it should .

perfect replacement. heats like the original without any issues.

After trouble shooting for weeks on Abnormal Temp failures on a S1 Pro, I finally cut the bed wire sheath apart and found a broken ground wire on my original bed. Outside of wire sheath looked perfectly fine but after removing sheath I finally found the problem. This bed is plug and play except it doesn’t have a ground wire. I drilled the back edge (where my original was) being careful not to drill into the heating area. Then I threaded it for a 8-32 tiny bolt. I also added insulation to the bottom of the bed and ran the wiring through some loom I already had. My printer is up and running again. I’d give 5 stars if it came with a ground wire and a beefier bed attachment to the bed.

Good drop in replacement for an ender 3 pro. The leads are soldered better than what I got from the factory and it appears to heat up quicker. You will likely need to tune the bed after installing, but I have been running this for a year or two without issue.

Drop in replacement and works perfectly for Ender 3

I used this as a replacement to my ender 3 S1. For the most part it does bolt straight up. Only difference is no ground wire connecting for plate to chassis, and no cable clamp. Mine also did NOT have the thermal blanket that was imaged. In comparison to my factory one (that warped), it takes about 6 mins to reach 60°c compared to my original 3mins. It works in a pinch.

When installing this unit there is a foil packed with a sticky side. This should go underneath the actual platen and the screws stick through it with the springs. I would not recommend using the rubber baby buggy bumpers underneath the platen. So far it's held the heat really even and really good. this is a great buy!

Broke the plug on my original bed plate when trying to install an upgrade. (Didn't realize it was glued to the board 🤦) Had the new bed installed and back to printing in about 15 minutes. Temp was spot on and performance was excellent.