HOBBYWING Quicrun Fusion SE 540 Spec (Fusion SE 1800KV)

I have 3 or 4 different fusions in my crawlers and I can't have anything else. Especially this SE is a great value, for being a sensored brushless motor, esc, and a built in 4Amp BEC, while being all sealed and waterproof.If this is your first Fusion, or Hobbywing product, know that it doesn't come with a programming card. You will need one to set it up, or borrow from a friend in the hobby. Then just enjoy this very powerfull, smooth and quiet setup. I know I am, and I will be back for more. Quality, performance, direct fit, pwerfull and clean installation with minimal wiring by having built-in ESC and BEC.

I installed this in my 6lb built crawler and powered it up to rnn it box stock to see if it was enough motor for my gear ratio(13t pinion, 56t spur in an scx10 transmission, injora portal axles, 2.2in. wheels) It's flawless as far as I'm concerned; It's good and slow, it has tons of torque, minimal wires to fight with at installation. I bought a program card, but I doubt I'll need to change many of the stock settings. This is so much easier to set up and run than my brushed setup. I'm a hobbywing fan now.

This motor is so good that it gave my truck enough wheel speed and probably a little bit more than the stock motor and has extreme torque to make your truck climb over stuff, the drag brake is why I purchased this motor and completely satisfied with it, sure the 1800kv motor is probably more ideal for a lot of people but the 1200kv is good enough for what I need and the run time last a little bit longer than the 1800kv but for crawling it's not a race truck so this one is fine, was easy to install, easy to setup and if you have the program card you can find tune it for some stuff just not like the fusion pro 2300kv

Works perfect in my axial scx103 basecamp and gladiator. Best bang for your buck upgrade in my opion. The slow control compared to a stock motor is night and day difference.

Easy to program. So much better than mybrush motor. More control. Being that it has the speed control built-in, allows more room.

Powerful and quite I love these two and one motor's I use this 1800kv or the pro2300kv in almost all my crawler's.

I have several different Fusion motors and the quality and fitment have always been good. This version is no exception. Lots of torque and quick response make this a good choice. Easy to use right out of the box. Mine needed no programming for use in my robotic project.

I’d have to say this is one of the best systems if you’re on a budget and looking to get great performance out of the box . Make sure to get a program card to fine tune . Great throttle control and lots of options to choose from for programming